EUVIMEDEUVIMED entdecken
Crossref

Rod Coaxial Antenna for Microwave Ablation

Zahra Mostajabi, J. Rashed-Mohassel

IEEE Journal of Electromagnetics, RF and Microwaves in Medicine and Biology · 2026-06 · 10 (2) · 279-286

DOI: 10.1109/jerm.2026.3660713 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IEEE Journal of Electromagnetics, RF and Microwaves in Medicine and Biology, 2026-06. Verfasst von Zahra Mostajabi und 1 weiteren Autor:innen. Die Arbeit nennt 32 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this paper, we propose a simple, compact, and low-cost antenna for microwave ablation applications. The antenna is based on a rod-assisted coaxial structure, which improves impedance matching through minimal structural modification while maintaining a compact geometry comparable to conventional coaxial probes and fabrication simplicity. Measurements and simulations show good agreement. Ablation performance is evaluated through conventional two-dimensional tissue sectioning, and two novel experimental methods, termed Delayed Ablation–Resection Pattern (DARP) and Minced Liver Ablation Pattern (MILAP), are introduced to obtain three-dimensional ablation-pattern information. Ovine and bovine liver, egg white, minced chicken liver, and minced ovine liver were used as test materials to assess antenna performance under different experimental conditions. The proposed antenna is particularly effective for small tumors. Experimental results demonstrate that an ablated region of approximately 1 cm in diameter can be achieved using continuous-wave excitation of 40 W for 3 minutes, and that the ablation zone can be enlarged by increasing either the applied power or the treatment duration. Because the antenna scattering parameters vary during ablation, as a result of material changes, a stepped adaptive-frequency strategy is employed to maintain effective antenna operation and minimize unintended heating along the insertion path. We show that sampling discrete frequency points, rather than sweeping the entire frequency range, is sufficient to achieve this objective. This adaptive approach enables the use of higher power levels or longer treatment durations while improving safety for both the patient and the power amplifier, as the antenna remains matched to the tissue load throughout the procedure. Notably, the proposed method is fully compatible with standard power amplifiers and does not require custom-designed units.

Zitieren

APA

Mostajabi, Z., & Rashed-Mohassel, J. (2026). Rod Coaxial Antenna for Microwave Ablation. IEEE Journal of Electromagnetics, RF and Microwaves in Medicine and Biology, 10(2), 279-286. https://doi.org/10.1109/jerm.2026.3660713

Vancouver

Mostajabi Z, Rashed-Mohassel J. Rod Coaxial Antenna for Microwave Ablation. IEEE Journal of Electromagnetics, RF and Microwaves in Medicine and Biology. 2026;10(2):279-286. doi:10.1109/jerm.2026.3660713

BibTeX
@article{Mostajabi2026,
  author = {Mostajabi, Zahra and Rashed-Mohassel, J.},
  title = {Rod Coaxial Antenna for Microwave Ablation},
  journal = {IEEE Journal of Electromagnetics, RF and Microwaves in Medicine and Biology},
  year = {2026},
  volume = {10},
  number = {2},
  pages = {279--286},
  doi = {10.1109/jerm.2026.3660713}
}
Kostenlos starten →