Design and Analysis of a 1.5-mW Ka-Band CMOS Quadrature VCO Using Core Transistors With Self-Forward-Bias and AC-Floating Body Topology
IEEE Access · 2026 · 14 · 83491-83499
DOI: 10.1109/access.2026.3697840 ↗Kurz gefasst
Fachartikel in der Zeitschrift IEEE Access, 2026. Verfasst von Yo-Sheng Lin und 1 weiteren Autor:innen. Die Arbeit nennt 12 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Science and Technology Council (NSTC) of Taiwan.
Abstract (Originalsprache)
This paper presents a Ka-band CMOS quadrature voltage-controlled oscillator (QVCO) designed for user-terminal transmitters in low Earth orbit (LEO) satellite communication (SATCOM) systems. The proposed QVCO core consists of two coupled differential VCOs. VCO-X is coupled to VCO-Y through two directly connected common-source (CS) transistors, while VCO-Y is coupled back to VCO-X via two cross-connected CS transistors. The cross-coupled transistors M1–M4 adopt a body-to-drain with resistor (B-to-D-with-R ${}_{\mathrm {B}}$ ) topology, in which the body is connected to the drain through a large body-floating resistor (R ${}_{\mathrm {B}}$ ) of 3.2 k $\Omega $ . This self-forward-biasing, AC-floating body configuration reduces the threshold voltage (V ${}_{\mathrm {th}}$ ) while suppressing substrate leakage and noise. Consequently, the transconductance (g ${}_{\mathrm {m}}$ ) and loop gain are enhanced, enabling robust low-voltage and low-power operation. Wideband differential I/Q signal generation is achieved using optimized RLC loads that exhibit an impedance phase of approximately −18.9°, rather than the conventional −45°. This approach increases the load impedance, and hence the loop gain, across the operating band. The NMOS varactors employ a body-to-ground with resistor (B-to-ground-with-R ${}_{\mathrm {B}}$ ) topology, providing a wide capacitance tuning range from 123.3 to 229.7 fF. In addition, a $\lambda $ /4 transmission line (TL) is incorporated into the control-voltage (V ${}_{\mathrm {ctrl}}$ ) bias path to ensure effective AC grounding at the center tap of the differential varactors. The QVCO operates with a 0.4 V supply voltage and consumes 1.5 mW of power. It achieves a 4.33 GHz tuning range (26.44–30.77 GHz), corresponding to a 15.1% fractional tuning range. The measured phase noise is −117.7 dBc/Hz at a 10 MHz offset from a 27.5 GHz carrier, resulting in a figure of merit (FoM) of 188.7 dBc/Hz, which ranks among the best reported for Ka-band CMOS QVCOs.
Förderung
- National Science and Technology Council (NSTC) of Taiwan
Zitieren
APA
Lin, Y., & Huang, C. (2026). Design and Analysis of a 1.5-mW Ka-Band CMOS Quadrature VCO Using Core Transistors With Self-Forward-Bias and AC-Floating Body Topology. IEEE Access, 14, 83491-83499. https://doi.org/10.1109/access.2026.3697840
Vancouver
Lin Y, Huang C. Design and Analysis of a 1.5-mW Ka-Band CMOS Quadrature VCO Using Core Transistors With Self-Forward-Bias and AC-Floating Body Topology. IEEE Access. 2026;14:83491-83499. doi:10.1109/access.2026.3697840
BibTeX
@article{Lin2026,
author = {Lin, Yo-Sheng and Huang, Chung-Ta},
title = {Design and Analysis of a 1.5-mW Ka-Band CMOS Quadrature VCO Using Core Transistors With Self-Forward-Bias and AC-Floating Body Topology},
journal = {IEEE Access},
year = {2026},
volume = {14},
pages = {83491--83499},
doi = {10.1109/access.2026.3697840}
}
EUVIMED