EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Opposition flow control for reducing skin-friction drag of a turbulent boundary layer

Giulio Dacome, Robin Mörsch, Marios Kotsonis, Woutijn J. Baars

Physical Review Fluids · 06.06.2024 · 9 (6)

DOI: 10.1103/physrevfluids.9.064602 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Physical Review Fluids, online erschienen am 06.06.2024. Verfasst von Giulio Dacome und 3 weiteren Autor:innen. Die Arbeit wurde bisher 20-mal zitiert (Crossref) und nennt 60 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Technische Universiteit Delft.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This work explores the dynamic response of a turbulent boundary layer to large-scale reactive opposition control, at a friction Reynolds number of Re τ ≈ 2 240 . A surface-mounted hot-film is employed as the input sensor, capturing large-scale fluctuations in the wall-shear stress, and actuation is performed with a single on/off wall-normal blowing jet positioned 2.4 δ downstream of the input sensor, operating with an exit velocity of v j = 0.4 U ∞ . Our study builds upon the work of Abbassi [] and includes a control-calibration experiment and a performance assessment using PIV- and PTV-based flow field analyses. With the control-off calibration-experiment conducted , a transfer kernel is identified so that the velocity fluctuations that are to-be-controlled can be estimated. The controller targets large-scale high-speed zones in an “opposing” mode and low-speed zones in a “reinforcing” mode. A desynchronized mode was tested for reference and consisted of a statistically similar control mode, but without synchronization to the incoming velocity fluctuations. An energy-attenuation of about 40 % is observed for the opposing control mode in the frequency band corresponding to the passage of large-scale motions. This proves the effectiveness of the control in targeting large-scale motions: an energy-intensification of roughly 45% occurs for the reinforcing control mode instead, while no change in energy, within the wall-normal range targeted, appears with the desynchronized control mode. Moreover, direct measures of the skin-friction drag are inferred from PTV data. Results indicate that the opposing control logic yields the lowest wall-shear stress (3% lower than the desynchronized control, and 10% lower than the uncontrolled flow). Finally, a FIK-decomposition of the skin-friction coefficient revealed that the off-the-wall turbulence follows a consistent trend with the PTV-based wall-shear stress measurements, although biased by an increased shear in the wake of the boundary layer given the formation of a plume due to the jet-in-crossflow actuation. Published by the American Physical Society 2024

Förderung

  • Technische Universiteit Delft

Zitieren

APA

Dacome, G., Mörsch, R., Kotsonis, M., & Baars, W. J. (2024). Opposition flow control for reducing skin-friction drag of a turbulent boundary layer. Physical Review Fluids, 9(6). https://doi.org/10.1103/physrevfluids.9.064602

Vancouver

Dacome G, Mörsch R, Kotsonis M, Baars WJ. Opposition flow control for reducing skin-friction drag of a turbulent boundary layer. Physical Review Fluids. 2024;9(6). doi:10.1103/physrevfluids.9.064602

BibTeX
@article{Dacome2024,
  author = {Dacome, Giulio and Mörsch, Robin and Kotsonis, Marios and Baars, Woutijn J.},
  title = {Opposition flow control for reducing skin-friction drag of a turbulent boundary layer},
  journal = {Physical Review Fluids},
  year = {2024},
  volume = {9},
  number = {6},
  doi = {10.1103/physrevfluids.9.064602}
}
Kostenlos starten →