EUVIMEDEUVIMED entdecken
Crossref

Development of ion-beam sputtered silicon nitride thin films for low-noise mirror coatings of gravitational-wave detectors

A. Amato, M. Bazzan, G. Cagnoli, M. Canepa, M. Coulon, J. Degallaix, N. Demos, A. Di Michele, M. Evans, F. Fabrizi, G. Favaro, D. Forest und 23 weitere

Physical Review D · 07.02.2025 · 111 (4)

DOI: 10.1103/physrevd.111.042003 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Physical Review D, online erschienen am 07.02.2025. Verfasst von A. Amato und 34 weiteren Autor:innen. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 72 Literaturangaben. Gefördert von: National Science Foundation, Horizon 2020 Framework Programme.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Brownian thermal noise of thin-film coatings is a fundamental limit for high-precision experiments based on optical resonators such as gravitational-wave interferometers. Here we present the results of a research activity aiming to develop lower-noise ion-beam sputtered silicon nitride thin films compliant with the very stringent requirements on optical loss of gravitational-wave interferometers. In order to test the hypothesis of a correlation between the synthesis conditions of the films and their elemental composition and optical and mechanical properties, we varied the voltage, current intensity and composition of the sputtering ion beam, and we performed a broad campaign of characterizations. While the refractive index was found to monotonically depend on the beam voltage and linearly vary with the N/Si ratio, the optical absorption appeared to be strongly sensitive to other factors, as yet unidentified. However, by systematically varying the deposition parameters, an optimal working point was found. Thus we show that the loss angle and extinction coefficient of our thin films can be as low as $(1.0 \pm 0.1) \times 10^{-4}$ rad at $\sim$2.8 kHz and $(6.4 \pm 0.2) \times 10^{-6}$ at 1064 nm, respectively, after thermal treatment at 900 $^{\circ}$C. To the best of our knowledge, such loss angle value is the lowest ever measured on this class of thin films. We then used our silicon nitride thin films to design and produce a multi-material mirror coating showing a thermal noise amplitude of $(10.3 \pm 0.2) \times 10^{-18}$ m Hz$^{-1/2}$ at 100 Hz, which is 25\% lower than in current mirror coatings of the Advanced LIGO and Advanced Virgo interferometers, and an optical absorption as low as $(1.6 \pm 0.5)$ parts per million at 1064 nm.

Förderung

  • National Science Foundation
  • Horizon 2020 Framework Programme

Zitieren

APA

Amato, A., Bazzan, M., Cagnoli, G., Canepa, M., Coulon, M., Degallaix, J., Demos, N., Michele, A. D., Evans, M., Fabrizi, F., Favaro, G., Forest, D., Gras, S., Hofman, D., Lemaître, A., Maggioni, G., Magnozzi, M., Martinez, V., Mereni, L., …, & Granata, M. (2025). Development of ion-beam sputtered silicon nitride thin films for low-noise mirror coatings of gravitational-wave detectors. Physical Review D, 111(4). https://doi.org/10.1103/physrevd.111.042003

Vancouver

Amato A, Bazzan M, Cagnoli G, Canepa M, Coulon M, Degallaix J, et al. Development of ion-beam sputtered silicon nitride thin films for low-noise mirror coatings of gravitational-wave detectors. Physical Review D. 2025;111(4). doi:10.1103/physrevd.111.042003

BibTeX
@article{Amato2025,
  author = {Amato, A. and Bazzan, M. and Cagnoli, G. and Canepa, M. and Coulon, M. and Degallaix, J. and Demos, N. and Michele, A. Di and Evans, M. and Fabrizi, F. and Favaro, G. and Forest, D. and Gras, S. and Hofman, D. and Lemaître, A. and Maggioni, G. and Magnozzi, M. and Martinez, V. and Mereni, L. and Michel, C. and Milotti, V. and Montani, M. and Paolone, A. and Pereira, A. and Piergiovanni, F. and Pierro, V. and Pinard, L. and Pinto, I. M. and Placidi, E. and Samandari, S. and Sassolas, B. and Shcheblanov, N. and Teillon, J. and Vickridge, I. and Granata, M.},
  title = {Development of ion-beam sputtered silicon nitride thin films for low-noise mirror coatings of gravitational-wave detectors},
  journal = {Physical Review D},
  year = {2025},
  volume = {111},
  number = {4},
  doi = {10.1103/physrevd.111.042003}
}
Kostenlos starten →