Electronic Cigarette Nicotine Flux, Nicotine Yield, and Particulate Matter Emissions: Impact of Device and Liquid Heterogeneity
Nicotine & Tobacco Research · 09.02.2023 · 25 (3) · 412-420
DOI: 10.1093/ntr/ntac196 ↗Kurz gefasst
Fachartikel in der Zeitschrift Nicotine & Tobacco Research, online erschienen am 15.08.2022. Verfasst von Eric K Soule und 9 weiteren Autor:innen. Beteiligte Einrichtung: Department of Health Education and Promotion, East Carolina University, Greenville, NC, USA. Hauptthemen laut MEDLINE: Electronic Nicotine Delivery Systems, Tobacco Products, Vaping. Die Arbeit wurde bisher 17-mal zitiert (Crossref) und nennt 50 Literaturangaben. Der Volltext ist frei in PubMed Central verfügbar. Gefördert von: NIEHS NIH HHS, NIGMS NIH HHS, NCI NIH HHS.
Abstract (Originalsprache)
Introduction
Electronic cigarettes (ECIGs) heat a nicotine-containing liquid to produce an inhalable aerosol. ECIG power (wattage) and liquid nicotine concentration are two factors that predict nicotine emission rate (“flux”). These factors can vary greatly across devices and users. Aims and Methods The purpose of this study was to examine ECIG device and liquid heterogeneity in “real world” settings and the association with predicted nicotine flux, nicotine yield, and total particulate matter (TPM) emissions. Past 30-day ECIG users (n = 84; mean age = 23.8 years [SD = 9.6]) reported device and liquid characteristics. Device power was measured via multimeter, device display screens, or obtained via labeling. Liquid nicotine concentration was obtained via labeling or through chemical analysis. Predicted nicotine flux, nicotine yield, and TPM associated with 10 4-second puffs were calculated for participants’ primary devices.
Results
Participants’ primary devices were box mods (42.9%), disposable vapes (20.2%), and pod mods (36.9%). Most participants (65.5%) reported not knowing their primary device wattage. Rebuildable/box mods had the greatest power range (11.1–120.0 W); pod mod power also varied considerably (4.1–21.7 W). Unlike device wattage, most participants (95.2%) reported knowing their liquid nicotine concentration, which ranged from 3.0 to 86.9 mg/ml (M = 36.0, SD = 29.3). Predicted nicotine flux varied greatly across products (range =12.0–160.1 μg/s, M = 85.6 μg/s, SD = 34.3). Box mods had the greatest variability in wattage and predicted nicotine flux, nicotine yield, and TPM yield.
Conclusions
ECIG device and liquid heterogeneity influence nicotine and other toxicant emissions. Better measurement of ECIG device and liquid characteristics is needed to understand nicotine and toxicant emissions and to inform regulatory policy.
Implications
ECIG device and liquid heterogeneity cause great variability in nicotine flux and toxicants emitted. These data demonstrate the need to examine device and liquid characteristics to develop empirically informed, health-promoting regulatory policies. Policies may include setting product standards such that ECIG products cannot (1) have nicotine fluxes much greater than that of a cigarette to decrease the risk of dependence, (2) have nicotine fluxes that are very low and thus would have minimal appeal to cigarette smokers and may serve as starter products for youth or nontobacco users, and (3) emit large amounts of particulate matter and other toxicants.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Substanzen
Autor:innen und Institutionen
- Department of Health Education and Promotion, East Carolina University, Greenville, NC, USA.
- Center for the Study of Tobacco Products, Virginia Commonwealth University, Richmond, VA, USA.
- Health Behavior and Policy, Virginia Commonwealth University, Richmond, VA, USA.
- Schroeder Institute, Truth Initiative, Washington, DC, USA.
- Pennington Biomedical Research Center, Louisiana State University System, Baton Rouge, LA, USA.
- Mechanical Engineering Department, Maroun Semaan Faculty of Engineering and Architecture, American University of Beirut, Beirut, Lebanon.
ORCID-Profile: Eric K Soule
Förderung
- NIEHS NIH HHS
- NIGMS NIH HHS
- NCI NIH HHS
- NIDA NIH HHS
- NIDDK NIH HHS
- National Cancer Institute
- National Institutes of Health
- Center for Tobacco Products
Zitieren
APA
Soule, E. K., Mayne, S., Snipes, W., Do, E. K., Theall, T., Höchsmann, C., Talih, S., Martin, C. K., Eissenberg, T., & Fuemmeler, B. F. (2023). Electronic Cigarette Nicotine Flux, Nicotine Yield, and Particulate Matter Emissions: Impact of Device and Liquid Heterogeneity. Nicotine & Tobacco Research, 25(3), 412-420. https://doi.org/10.1093/ntr/ntac196
Vancouver
Soule EK, Mayne S, Snipes W, Do EK, Theall T, Höchsmann C, et al. Electronic Cigarette Nicotine Flux, Nicotine Yield, and Particulate Matter Emissions: Impact of Device and Liquid Heterogeneity. Nicotine & Tobacco Research. 2023;25(3):412-420. doi:10.1093/ntr/ntac196
BibTeX
@article{Soule2023,
author = {Soule, Eric K and Mayne, Shannon and Snipes, William and Do, Elizabeth K and Theall, Travis and Höchsmann, Christoph and Talih, Soha and Martin, Corby K and Eissenberg, Thomas and Fuemmeler, Bernard F},
title = {Electronic Cigarette Nicotine Flux, Nicotine Yield, and Particulate Matter Emissions: Impact of Device and Liquid Heterogeneity},
journal = {Nicotine & Tobacco Research},
year = {2023},
volume = {25},
number = {3},
pages = {412--420},
doi = {10.1093/ntr/ntac196}
}
EUVIMED