Off-Axis Electron Holography of Point Defects in Semiconductor Devices
Microscopy and Microanalysis · 27.07.2026 · 32 (Supplement_1)
DOI: 10.1093/mam/ozag053.597 ↗Kurz gefasst
Fachartikel in der Zeitschrift Microscopy and Microanalysis, online erschienen am 27.07.2026. Verfasst von Keyan Ji und 4 weiteren Autor:innen. Die Arbeit nennt 3 Literaturangaben.
Abstract (Originalsprache)
Point defects are notoriously difficult to characterize using transmission electron microscopy (TEM), techniques, not only structurally and compositionally but also electronically. Here, we use off-axis electron holography to identify the type and energy of point defects in Si-doped GaN samples prepared for TEM examination using focused ion beam (FIB) milling, both before and after in situ annealing. The sample studied here comprises a GaN layer that was grown using metal organic vapor phase epitaxy on a c-plane GaN pseudosubstrate, followed by Si δ-doping at 5 × 1019 cm−3 in the first 20 nm and 3 × 1018 cm−3 in the remaining 700-nm-thick layer, respectively. No dislocations or stacking faults were detected in the layers. An electron-transparent lamella was prepared using FIB milling, after depositing a 2-μm-thick C protection layer. Final milling was performed with decreasing acceleration voltages of 30, 15 and 5 kV at grazing incidence angles of 2, 1.2, and 5° of the Ga+ ion beam, respectively, under simultaneous reduction of the current. The crystalline thickness of the lamella was measured using convergent beam electron diffraction (CBED), while the amorphous shell thickness was determined by subtracting the thickness measured by CBED from that obtained using scanning electron microscopy. The left side of Fig. 1 shows representative amplitude and phase images recorded using off-axis electron holography at 300 kV in an image-aberration-corrected TEM equipped with an electron biprism [1]. The sample was tilted to a weakly diffracting condition, while maintaining an edge-on orientation of the layers. Phase profiles were extracted along the [0001] growth direction. The sample temperature was increased in situ in the TEM in steps of typically 50 °C every 30 minutes. The right side of Fig. 1 compares measured temperature-dependent phase profiles with corresponding best-fitting simulated profiles, which were calculated by using a self-consistent finite-difference based Poisson solver and determining the electron phase within the framework of the phase object approximation by integrating the three-dimensional electrostatic potential in the electron beam direction, followed by running average broadening of 4 nm in line with the measurement resolution. The best-fitting simulations to the experimental results suggest that the surface of the crystalline core of a freshly-FIB-prepared GaN lamella exhibits a Fermi level pinning of 0.57 eV above the valence band edge. This value is attributed to the subsitutational implantation of C on N sites in the near-surface region during FIB milling. The pinning level is observed to increase to ∼2 eV above the valence band edge upon annealing between 250 °C and 500 °C and to remain high after cooling to room temperature. This behavior is indicative of irreversible thermal healing, which gradually reduces the implanted C concentration. The higher midgap pinning level is then attributed to crystalline core- amorphous shell interface states. The results suggest that the dominant point defect type is substitutional C on N sites and that annealing temperatures as low as about 250 °C are sufficient to initiate defect healing. The implantation of C into the crystalline inner shell of the lamella is corroborated by calculations, which confirm C penetration into GaN by up to 15 nm. In a separate study [2], the dynamics of C-implanted defects in GaN upon annealing were examined in more detail using off-axis electron holography. Switching of C from substitutional to interstitial sites was confirmed to be the atomic process responsible for lifting the Fermi-level pinning in the lower part of the band gap, with an activation barrier energy for the site switching process of 2.27 ± 0.26 eV [3]. (Left) Amplitude and phase images recorded at 500 °C using off-axis electron holography. The vertical contrast line at 0 nm is associated with the presence of a δ-doping-like layer. The overlaid phase profile is extracted from a region free from dynamical diffraction contrast (marked by a blue dotted rectangle). (Right) Comparison of experimental (symbols) and simulated (lines) electron phase profiles recorded at different sample temperatures in the low temperature (⩽250 °C) regime. Schematic diagrams of a cross-sectional GaN TEM lamella in the (left) as-prepared and (b) annealed state. FIB preparation results in an amorphous outer shell (light blue circles) covering a crystalline core (dark blue circles). In the as-prepared state, directly below the amorphous shell (mid blue circles) is a further inner crystalline shell that contains a high concentration of FIB-induced point defects (red circles), leading to Fermi level pinning Fermi level pinning 0.57 eV above the valence band. This defect-rich crystalline inner shell is electrically inactive (red zone). The total thickness of the electrically dead layer (amorphous outer plus defect-rich inner shell) can be estimated from calculations, which suggest that surface C is implanted with a penetration depth of up to 15 nm. After annealing, the defects heal, restoring the pristine crystal. The amorphous outer layer then exhibits mid-gap Fermi level pinning.
Zitieren
APA
Ji, K., Schnedler, M., Lan, Q., Dunin-Borkowski, R. E., & Ebert, P. (2026). Off-Axis Electron Holography of Point Defects in Semiconductor Devices. Microscopy and Microanalysis, 32(Supplement_1). https://doi.org/10.1093/mam/ozag053.597
Vancouver
Ji K, Schnedler M, Lan Q, Dunin-Borkowski RE, Ebert P. Off-Axis Electron Holography of Point Defects in Semiconductor Devices. Microscopy and Microanalysis. 2026;32(Supplement_1). doi:10.1093/mam/ozag053.597
BibTeX
@article{Ji2026,
author = {Ji, Keyan and Schnedler, Michael and Lan, Qianqian and Dunin-Borkowski, Rafal E and Ebert, Philipp},
title = {Off-Axis Electron Holography of Point Defects in Semiconductor Devices},
journal = {Microscopy and Microanalysis},
year = {2026},
volume = {32},
number = {Supplement_1},
doi = {10.1093/mam/ozag053.597}
}
EUVIMED