Needle length in pines as a key trait regulating hydraulic resistance
Annals of Botany · 2026
DOI: 10.1093/aob/mcaf174 ↗Kurz gefasst
Fachartikel in der Zeitschrift Annals of Botany, 2026. Verfasst von Giovanni Bicego und 3 weiteren Autor:innen. Beteiligte Einrichtung: Department Territorio e Sistemi Agro-Forestali, Università degli Studi di Padova, Viale dell'Università 16, Legnaro, PD 35020, Italy. Hauptthemen laut MEDLINE: Pinus, Plant Leaves, Water, Plant Transpiration. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 82 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: PAPIIT-DGAPA (UNAM).
Abstract (Originalsprache)
Background and Aims In conifers, leaf length exhibits remarkable variation across and within species, even within the same individual. Leaves are often shorter in drier sites and at the tops of taller trees. Several hypotheses have been proposed to explain this shortening, but a clear causal framework is lacking. We hypothesize that conifer needles should exhibit a low rate of tip-to-base conduit widening leading to higher hydraulic resistance in long needles, explaining adaptive leaf shortening.
Methods
We sampled needles from 22 Pinus species and one Sequoia sempervirens across a range of environmental conditions. We conducted a detailed intraspecific analysis on four Pinus species by measuring tracheid diameter along the needle, and an interspecific comparison by measuring tracheid diameter at the needle base across all species. In both analyses, we fitted tracheid diameter against distance from the needle tip and calculated the slope (b) of tip-to-base tracheid widening. Key Results A low mean intraspecific widening slope (b = 0.12) was found, indicating that tracheid diameter increases only slightly from tip to base. This low widening rate cannot fully compensate for the increase in hydraulic resistance, which therefore increases with needle length. The interspecific slope of mean tracheid diameter at the needle base vs. needle length (0.25) was higher than the intraspecific mean, suggesting that longer-needled species may have wider conduits at the needle apex, offsetting needle length-imposed resistance.
Conclusions
Our findings suggest that shorter needles should reduce hydraulic resistance under dry conditions or with height growth, maintaining leaf-specific conductance. We offer a novel explanation for the commonly observed pattern of needle shortening, interpreting it as an adaptive response rather than a physiological limitation.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Department Territorio e Sistemi Agro-Forestali, Università degli Studi di Padova, Viale dell'Università 16, Legnaro, PD 35020, Italy.
- Instituto de Biología, Universidad Nacional Autónoma de México, Tercer Circuito Exterior s/n, Ciudad Universitaria, Ciudad de México 04510, Mexico.
ORCID-Profile: Giovanni Bicego, Mark E Olson, David S Gernandt, Tommaso Anfodillo
Förderung
- PAPIIT-DGAPA (UNAM)
Zitieren
APA
Bicego, G., Olson, M. E., Gernandt, D. S., & Anfodillo, T. (2026). Needle length in pines as a key trait regulating hydraulic resistance. Annals of Botany. https://doi.org/10.1093/aob/mcaf174
Vancouver
Bicego G, Olson ME, Gernandt DS, Anfodillo T. Needle length in pines as a key trait regulating hydraulic resistance. Annals of Botany. 2026. doi:10.1093/aob/mcaf174
BibTeX
@article{Bicego2026,
author = {Bicego, Giovanni and Olson, Mark E and Gernandt, David S and Anfodillo, Tommaso},
title = {Needle length in pines as a key trait regulating hydraulic resistance},
journal = {Annals of Botany},
year = {2026},
doi = {10.1093/aob/mcaf174}
}
EUVIMED