EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC 4.0

Characterization of particle exposure during tunnel excavation by tunnel boring machines

Torunn K Ervik iD, Mimmi Leite, Stephan Weinbruch, Karl-Christian Nordby, Dag G Ellingsen, Bente Ulvestad, Kari Dahl, Balazs Berlinger, Nils Petter Skaugset

Annals of Work Exposures and Health · 2024

DOI: 10.1093/annweh/wxae041 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Annals of Work Exposures and Health, 2024. Verfasst von Torunn K Ervik und 8 weiteren Autor:innen. Beteiligte Einrichtung: National Institute of Occupational Health, P.O. Box 5330, Majorstuen, 0304 Oslo, Norway. Hauptthemen laut MEDLINE: Particle Size, Occupational Exposure, Particulate Matter, Air Pollutants, Occupational. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 48 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC 4.0). Gefördert von: Bane-Nor.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Tunnel boring machines (TBMs) are used to excavate tunnels in a manner where the rock is constantly penetrated with rotating cutter heads. Fine particles of the rock minerals are thereby generated. Workers on and in the vicinity of the TBM are exposed to particulate matter (PM) consisting of bedrock minerals including α-quartz. Exposure to respirable α-quartz remains a concern because of the respiratory diseases associated with this exposure. The particle size distribution of PM and α-quartz is of special importance because of its influence on adverse health effects, monitoring and control strategies as well as accurate quantification of α-quartz concentrations. The major aim of our study was therefore to investigate the particle size distribution of airborne PM and α-quartz generated during tunnel excavation using TBMs in an area dominated by gneiss, a metamorphic type of rock. Sioutas cascade impactors were used to collect personal samples on 3 separate days. The impactor fractionates the dust in 5 size fractions, from 10 µm down to below 0.25 µm. The filters were weighted, and the α-quartz concentrations were quantified using X-ray diffraction (XRD) analysis and the NIOSH 7500 method on the 5 size fractions. Other minerals were determined using Rietveld refinement XRD analysis. The size and elemental composition of individual particles were investigated by scanning electron microscopy. The majority of PM mass was collected on the first 3 stages (aerodynamic diameter = 10 to 0.5 µm) of the Sioutas cascade impactor. No observable differences were found for the size distribution of the collected PM and α-quartz for the 3 sampling days nor the various work tasks. However, the α-quartz proportion varied for the 3 sampling days demonstrating a dependence on geology. The collected α-quartz consisted of more particles with sizes below 1 µm than the calibration material, which most likely affected the accuracy of the measured respirable α-quartz concentrations. This potential systematic error is important to keep in mind when analyzing α-quartz from occupational samples. Knowledge of the particle size distribution is also important for control measures, which should target particle sizes that efficiently capture the respirable α-quartz concentration.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

Particle SizeOccupational ExposureParticulate MatterAir Pollutants, OccupationalHumansInhalation ExposureEnvironmental MonitoringQuartzDustX-Ray DiffractionConstruction Industry

Stichwörter der Autor:innen

TBMTunnel excavationimpactorparticulate matterquartz

Substanzen

Particulate MatterAir Pollutants, OccupationalQuartzDust

Autor:innen und Institutionen

  • National Institute of Occupational Health, P.O. Box 5330, Majorstuen, 0304 Oslo, Norway.
  • Technical University of Darmstadt, Institute of Applied Geosciences, Schnittspahnstrasse 9, D-64287, Darmstadt, Germany.

ORCID-Profile: Torunn K Ervik

Förderung

  • Bane-Nor

Zitieren

APA

Ervik, T. K., Leite, M., Weinbruch, S., Nordby, K. C., Ellingsen, D. G., Ulvestad, B., Dahl, K., Berlinger, B., & Skaugset, N. P. (2024). Characterization of particle exposure during tunnel excavation by tunnel boring machines. Annals of Work Exposures and Health. https://doi.org/10.1093/annweh/wxae041

Vancouver

Ervik TK, Leite M, Weinbruch S, Nordby KC, Ellingsen DG, Ulvestad B, et al. Characterization of particle exposure during tunnel excavation by tunnel boring machines. Annals of Work Exposures and Health. 2024. doi:10.1093/annweh/wxae041

BibTeX
@article{Ervik2024,
  author = {Ervik, Torunn K and Leite, Mimmi and Weinbruch, Stephan and Nordby, Karl-Christian and Ellingsen, Dag G and Ulvestad, Bente and Dahl, Kari and Berlinger, Balazs and Skaugset, Nils Petter},
  title = {Characterization of particle exposure during tunnel excavation by tunnel boring machines},
  journal = {Annals of Work Exposures and Health},
  year = {2024},
  doi = {10.1093/annweh/wxae041}
}
Kostenlos starten →