Numerical simulation and experimental investigation of surface roughness during internal finishing of thin-walled slender tubes with a cylindrical diamond tool
Surface Topography: Metrology and Properties · 10.11.2026
DOI: 10.1088/2051-672x/aec033 ↗Kurz gefasst
Fachartikel in der Zeitschrift Surface Topography: Metrology and Properties, online erschienen am 10.11.2026. Verfasst von Congcong Gao und 3 weiteren Autor:innen. Gefördert von: Jiangsu Key Laboratory of Precision and Micro-Manufacturing Technology.
Abstract (Originalsprache)
This paper used a cylindrical diamond tool to finish the inner surface of thin-walled slender tubes. Considering the actual geometry and protrusion height of diamond abrasives, the abrasive-workpiece interactions involving rubbing, plowing and cutting during finishing were analyzed using contact mechanics theory. A mechanical model was established to correlate macroscopic contact force with the microscopic force acting on a single abrasive, whereby the cutting depth of the abrasive was calculated. The abrasive trajectory was subsequently analyzed based on kinematic theory, the material removal distribution was further determined, thereby establishing a predictive model for workpiece surface roughness. The single-factor polishing verification experiments were conducted and the simulated results of the model agreed well with the experimental results, with an average error below 15%. Meanwhile, the influence of various process parameters on the surface roughness was analyzed. After polishing for 45 min at an elongation of 20 mm, a workpiece feed speed of 600 mm/s, the surface roughness Sa was reduced from the initial value of 1.046 μm to 0.362 μm. A smooth surface without micro-peaks was obtained.
Förderung
- Jiangsu Key Laboratory of Precision and Micro-Manufacturing Technology
Zitieren
APA
Gao, C., Gao, Y., Zhang, W., & Deng, Y. (2026). Numerical simulation and experimental investigation of surface roughness during internal finishing of thin-walled slender tubes with a cylindrical diamond tool. Surface Topography: Metrology and Properties. https://doi.org/10.1088/2051-672x/aec033
Vancouver
Gao C, Gao Y, Zhang W, Deng Y. Numerical simulation and experimental investigation of surface roughness during internal finishing of thin-walled slender tubes with a cylindrical diamond tool. Surface Topography: Metrology and Properties. 2026. doi:10.1088/2051-672x/aec033
BibTeX
@article{Gao2026,
author = {Gao, Congcong and Gao, Yuewu and Zhang, Wanqing and Deng, Yueming},
title = {Numerical simulation and experimental investigation of surface roughness during internal finishing of thin-walled slender tubes with a cylindrical diamond tool},
journal = {Surface Topography: Metrology and Properties},
year = {2026},
doi = {10.1088/2051-672x/aec033}
}
EUVIMED