EUVIMEDEUVIMED entdecken
Crossref

Fabrication of array microelectrodes: achieving geometrical characteristics using reverse micro-EDM process

Suresh Pratap, Somak Datta

Physica Scripta · 01.08.2023 · 98 (8) · 085003

DOI: 10.1088/1402-4896/ace224 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Physica Scripta, online erschienen am 06.07.2023. Verfasst von Suresh Pratap und 1 weiteren Autor:innen. Die Arbeit wurde bisher 18-mal zitiert (Crossref) und nennt 21 Literaturangaben.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Reverse micro-EDM is the most suitable method for fabricating circular cross-section array microelectrodes. This work presents an experimental investigation into the effect of process parameters such as capacitance, voltage, and feed on the geometrical characteristics (diameter, length, and taper) of tungsten carbide (WC) array microelectrodes. Using a ø2 mm × 35 mm length rod of tungsten carbide, a 3 × 3 array of microelectrodes was fabricated with a 230 μ m diameter hole in a copper sheet, providing a depth of 1.5 mm. Increasing the process parameters from 10 nF capacitance, 90 V voltage, and 0.3 mm min −1 feed to 100 nF capacitance, 130 V voltage, and 0.9 mm min −1 feed decreased the diameter by 6.75% and increased the taper of the electrodes by 3%. The ANOVA analysis indicates that capacitance, voltage, and feed significantly affect the geometrical characteristics of array microelectrodes. Using the multi-objective optimization technique grey relational analysis (GRA), it was found that at a capacitance of 10 nF, a voltage of 130 V, and a feed rate of 0.3 mm min −1 achieved the minimum deviation in the geometrical characteristics of WC array microelectrodes. This paper will help determine the hole size required to achieve the specific dimensions on the array microelectrodes and select optimal process parameters.

Zitieren

APA

Pratap, S., & Datta, S. (2023). Fabrication of array microelectrodes: achieving geometrical characteristics using reverse micro-EDM process. Physica Scripta, 98(8), 085003. https://doi.org/10.1088/1402-4896/ace224

Vancouver

Pratap S, Datta S. Fabrication of array microelectrodes: achieving geometrical characteristics using reverse micro-EDM process. Physica Scripta. 2023;98(8):085003. doi:10.1088/1402-4896/ace224

BibTeX
@article{Pratap2023,
  author = {Pratap, Suresh and Datta, Somak},
  title = {Fabrication of array microelectrodes: achieving geometrical characteristics using reverse micro-EDM process},
  journal = {Physica Scripta},
  year = {2023},
  volume = {98},
  number = {8},
  pages = {085003},
  doi = {10.1088/1402-4896/ace224}
}
Kostenlos starten →