EUVIMEDEUVIMED entdecken
Crossref

Effects of printing parameters on 4D-printed PLA actuators

Yousif Saad Alshebly, Marwan Nafea

Smart Materials and Structures · 01.06.2023 · 32 (6) · 064008

DOI: 10.1088/1361-665x/acd504 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Smart Materials and Structures, online erschienen am 19.05.2023. Verfasst von Yousif Saad Alshebly und 1 weiteren Autor:innen. Die Arbeit wurde bisher 50-mal zitiert (Crossref) und nennt 37 Literaturangaben. Gefördert von: The Ministry of Higher Education Malaysia under the Fundamental Research Grant Scheme.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Controlling the printing parameters of four-dimensional (4D) printed actuators can be used to set the internal strain of the actuators. This approach can be utilised when using the fused deposition modelling method to develop 4D-printed actuators, allowing non-manual shape programming. However, there is a lack of comprehensive studies that investigate the effects of printing parameters on the actuation performance of 4D-printed actuators. In this study, the effects of four printing parameters on the bending angle of 4D-printed polylactic acid (PLA) actuators are reported. These printing parameters include the printing speed, printing temperature, ratio of passive-to-active layers, and layer height. In addition, these printing parameters are investigated while changing the height of the actuators. The results show that increasing the printing speed increases the internal strain while increasing the printing temperature, layer height, or actuator height has the opposite effect. Moreover, it is found that a ratio of passive-to-active layers of 50% maximises the strain while selecting a higher or lower ratio causes the opposite effect. Based on the results, four mathematical predictive models are developed to determine the bending angle induced in the actuators when printed based on each printing parameter. Then, a predictive model that relates all the printing parameters and actuator height to the bending angle is developed. The predictive model is based on the characterization results of 534 PLA actuators, providing an R -squared value of 0.98. Then, a finite element analysis model is developed to replicate the shape memory effect in actuators. To prove the accuracy of the proposed concept, two grippers with four and eight fingers are developed. The results show that the printing parameters can be used to control the bending angle of each finger based on the design specifications.

Förderung

  • The Ministry of Higher Education Malaysia under the Fundamental Research Grant Scheme

Zitieren

APA

Alshebly, Y. S., & Nafea, M. (2023). Effects of printing parameters on 4D-printed PLA actuators. Smart Materials and Structures, 32(6), 064008. https://doi.org/10.1088/1361-665x/acd504

Vancouver

Alshebly YS, Nafea M. Effects of printing parameters on 4D-printed PLA actuators. Smart Materials and Structures. 2023;32(6):064008. doi:10.1088/1361-665x/acd504

BibTeX
@article{Alshebly2023,
  author = {Alshebly, Yousif Saad and Nafea, Marwan},
  title = {Effects of printing parameters on 4D-printed PLA actuators},
  journal = {Smart Materials and Structures},
  year = {2023},
  volume = {32},
  number = {6},
  pages = {064008},
  doi = {10.1088/1361-665x/acd504}
}
Kostenlos starten →