Research on hybrid processing of silicon carbide based on laser cutting
Semiconductor Science and Technology · 31.03.2025 · 40 (3) · 035009
DOI: 10.1088/1361-6641/ada9c8 ↗Kurz gefasst
Fachartikel in der Zeitschrift Semiconductor Science and Technology, online erschienen am 13.02.2025. Verfasst von Jinhu Wang und 8 weiteren Autor:innen. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 33 Literaturangaben. Gefördert von: National Natural Science Foundation of China, Jinan Science and Technology SMEs Innovation Capacity Enhancement Project, Natural Science Foundation of Shandong Province.
Abstract (Originalsprache)
With the rapid development of semiconductor technology, silicon carbide has been widely used in various power electronic device. However, the material has an extremely high hardness ranking second only to diamond, which makes processing difficult. In this work, the two methods of laser cutting and dicing saw are utilized to test the cutting process of silicon carbide respectively, then the appropriate through-cutting process parameters are obtained. The two methods are combined to compare the cutting quality of the three approaches. As a result, the laser cutting is affected by heat with through-cutting 0.5 mm-thick silicon carbide, which results in the rough front-surface edge and much residue, and the cutting groove of the back surface is irregular. The dicing saw having more mechanical stress, resulting in serious tool wear, prone to chipping and micro-cracks and other phenomena, the back surface chipping is as high as 171.6 µ m. The hybrid processing method not only reduces the degree of thermal damage, but also reduces tool wear, and the front surface is flat and clean after cutting, without a chipping phenomenon, and the back surface chipping is only 7.9 µ m, which is 20 times lower than the dicing saw method.
Förderung
- National Natural Science Foundation of China
- Jinan Science and Technology SMEs Innovation Capacity Enhancement Project
- Natural Science Foundation of Shandong Province
- Shandong Key Research and Development Program
Zitieren
APA
Wang, J., Jiang, K., Yue, X., Zhang, Q., Wang, C., Jing, X., Wang, J., Tang, W., & Xia, W. (2025). Research on hybrid processing of silicon carbide based on laser cutting. Semiconductor Science and Technology, 40(3), 035009. https://doi.org/10.1088/1361-6641/ada9c8
Vancouver
Wang J, Jiang K, Yue X, Zhang Q, Wang C, Jing X, et al. Research on hybrid processing of silicon carbide based on laser cutting. Semiconductor Science and Technology. 2025;40(3):035009. doi:10.1088/1361-6641/ada9c8
BibTeX
@article{Wang2025,
author = {Wang, Jinhu and Jiang, Kai and Yue, Xiuhui and Zhang, Qianyong and Wang, Cuishan and Jing, Xueting and Wang, Jing and Tang, Wenjing and Xia, Wei},
title = {Research on hybrid processing of silicon carbide based on laser cutting},
journal = {Semiconductor Science and Technology},
year = {2025},
volume = {40},
number = {3},
pages = {035009},
doi = {10.1088/1361-6641/ada9c8}
}
EUVIMED