Visualizing laminar-turbulent flow transition dynamics on wind turbines by means of thermography and a co-rotating measurement platform
Measurement Science and Technology · 26.06.2026 · 37 (26) · 265405
DOI: 10.1088/1361-6501/ae799a ↗Kurz gefasst
Fachartikel in der Zeitschrift Measurement Science and Technology, online erschienen am 30.06.2026. Verfasst von J Dieckmann und 5 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Deutsche Forschungsgemeinschaft.
Abstract (Originalsprache)
The efficiency of wind turbines is significantly influenced by the boundary layer flow on the rotor blades, particularly the position of the laminar–turbulent transition. To capture the transition position dynamics on operating turbines, an in-process capable measurement system with high temporal resolution is required. Therefore, a novel co-rotating measurement platform is presented that allows for continuous infrared thermographic observation of a rotor blade section, significantly improving the ‘once per revolution’ sampling rate limitation of non-rotating setups. In addition, a coupled thermal-flow simulation estimates the minimal thermal response time to be approximately 1.5 s after which a flow change is visible with a contrast-to-noise ratio of 5. This suggests that resolving transition changes within a single rotor revolution is physically feasible. The theoretical feasibility agrees with experimental results from a 2 MW wind turbine, where a sufficiently high contrast-to-noise ratio of 10.5 for a full revolution confirmed sufficient sensitivity to perform multiple distinct transition measurements per revolution. As a central result, transition changes are observed in agreement with the varying tip-speed ratio, which here serves as a reference for inflow dynamics. Furthermore, differential infrared thermography is successfully tested to isolate and visualize flow-driven changes during stable viewing conditions. For a precise quantitative comparison of flow transition across full revolutions, however, a compensation of perspective distortions and viewing-angle-dependent emissivity on the basis of the 3d blade geometry is required in future.
Förderung
- Deutsche Forschungsgemeinschaft
Zitieren
APA
Dieckmann, J., Oehme, F., Freyberg, A. V., Poeck, N., Balaresque, N., & Fischer, A. (2026). Visualizing laminar-turbulent flow transition dynamics on wind turbines by means of thermography and a co-rotating measurement platform. Measurement Science and Technology, 37(26), 265405. https://doi.org/10.1088/1361-6501/ae799a
Vancouver
Dieckmann J, Oehme F, Freyberg AV, Poeck N, Balaresque N, Fischer A. Visualizing laminar-turbulent flow transition dynamics on wind turbines by means of thermography and a co-rotating measurement platform. Measurement Science and Technology. 2026;37(26):265405. doi:10.1088/1361-6501/ae799a
BibTeX
@article{Dieckmann2026,
author = {Dieckmann, J and Oehme, F and Freyberg, A von and Poeck, N and Balaresque, N and Fischer, A},
title = {Visualizing laminar-turbulent flow transition dynamics on wind turbines by means of thermography and a co-rotating measurement platform},
journal = {Measurement Science and Technology},
year = {2026},
volume = {37},
number = {26},
pages = {265405},
doi = {10.1088/1361-6501/ae799a}
}
EUVIMED