EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Self-biased magnetoelectric Ni/LiNbO₃/Ni composites: from material characterisation to a battery-free implantable node

Hakeim Talleb, Manar Touati, Samir Beldi, Yunlin Zheng, Aurélie Gensbittel, Erwan Dandeu, Spencerh Bidouba, Tianwen Huang, Bingbing Xia, Massimiliano Marangolo

Journal of Physics D: Applied Physics · 06.11.2026

DOI: 10.1088/1361-6463/aebee0 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Physics D: Applied Physics, online erschienen am 06.11.2026. Verfasst von Hakeim Talleb und 9 weiteren Autor:innen. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Institut des sciences de l'ingénierie et des systèmes.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Self-biased magnetoelectric (ME) composites, which convert a magnetic field into electricity with no static bias, are attractive for powering battery-free, deeply implanted microsystems through tissue without heating it, while returning their data. This paper develops a self-biased Ni/LiNbO₃/Ni composite in which sputter-deposited nickel acts both as the magnetostrictive phase and as the electrodes; an intrinsic residual stress (≈ 50 MPa, confirmed by temperature-dependent VSM) supplies the bias and removes the static field, permanent magnets and epoxy bonding of conventional ME laminates. A unified equivalent circuit, a Mason model reduced near resonance to a Butterworth–Van Dyke network closed by a magneto-mechanical gyrator and a piezoelectric transformer, all elements extracted in closed form from impedance and VSM data, predicts the deliverable power within a factor of two across four composites over two decades of output, and is ready for end-to-end co-simulation in SPICE (Simulation Program with Integrated Circuit Emphasis). Guided by a fill-factor and skin-depth design study, an optimised sample raises the output from ≈ 1 V / 16 µW to 8.5 V / 0.33 mW self-biased (1.5 mW under a small bias). This power is shown, by circuit simulation on the measured source and by a measured-power budget, to run a complete battery-free node: the ME link supplies a pressure sensor, its analogue-to-digital converter and a microcontroller, a 13.56 MHz backscatter channel returns the data, and the harvested power lets a semi-active uplink clear the range limit of passive backscatter at 10 cm. A dosimetric and thermal analysis shows the low operating frequency to be a primary safety enabler (induced field and SAR scale as f and f²): the ME link deposits 50 to 130 times less specific absorption rate than an iso-footprint 13.56 MHz inductive link operated at the field its own standard permits.

Förderung

  • Institut des sciences de l'ingénierie et des systèmes

Zitieren

APA

Talleb, H., Touati, M., Beldi, S., Zheng, Y., Gensbittel, A., Dandeu, E., Bidouba, S., Huang, T., Xia, B., & Marangolo, M. (2026). Self-biased magnetoelectric Ni/LiNbO₃/Ni composites: from material characterisation to a battery-free implantable node. Journal of Physics D: Applied Physics. https://doi.org/10.1088/1361-6463/aebee0

Vancouver

Talleb H, Touati M, Beldi S, Zheng Y, Gensbittel A, Dandeu E, et al. Self-biased magnetoelectric Ni/LiNbO₃/Ni composites: from material characterisation to a battery-free implantable node. Journal of Physics D: Applied Physics. 2026. doi:10.1088/1361-6463/aebee0

BibTeX
@article{Talleb2026,
  author = {Talleb, Hakeim and Touati, Manar and Beldi, Samir and Zheng, Yunlin and Gensbittel, Aurélie and Dandeu, Erwan and Bidouba, Spencerh and Huang, Tianwen and Xia, Bingbing and Marangolo, Massimiliano},
  title = {Self-biased magnetoelectric Ni/LiNbO₃/Ni composites: from material characterisation to a battery-free implantable node},
  journal = {Journal of Physics D: Applied Physics},
  year = {2026},
  doi = {10.1088/1361-6463/aebee0}
}
Kostenlos starten →