A passive MEMS check valve for an isolated micro pressure vessel and micro-stirling engine development
Journal of Micromechanics and Microengineering · 19.11.2026
DOI: 10.1088/1361-6439/aec459 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Micromechanics and Microengineering, online erschienen am 19.11.2026. Verfasst von Timothy James Cheng und 4 weiteren Autor:innen. Gefördert von: Charles Stark Draper Laboratory.
Abstract (Originalsprache)
A micro-Stirling engine is under development for efficient electrical power generation from thermal sources at the centimeter scale. A vital component for efficient operation is a highly pressurized working fluid on the order of 1 MPa. To evaluate fabrication methods and the structural integrity of micro-Stirling engine components at these pressures, a novel isolated micro pressure vessel was designed with a check valve to allow repeated pressurization. Such a device will enable stress testing at varying pressures and compositions to optimize bond methods and the thin-walled glass housing design necessary for engine operation. In this work, we describe microscale check valves that close at pressures ranging from 47 to 188 kPa. The helium leakage when closed was found to be between 0.006 and 0.03 SCCM in the 50 to 200 kPa range. The flow rate when open was 2 orders of magnitude larger than this. The measured flowrates in the valve were higher than predictions by continuum models and gas rarefaction was found to be the cause for the discrepancy. The valves also closed at pressures approximately half what was predicted through structural stiffness and force balancing, this effect could not be fully explained with rarefied gas models. The details of these observations will be discussed. Ultimately, the best valve design for filling a micro pressure vessel should achieve a 1% pressure loss after 5 minutes post filling. This is well suited for the evaluation of pressure vessel bond strength and wall integrity for future micro-Stirling engine development.
Förderung
- Charles Stark Draper Laboratory
Zitieren
APA
Cheng, T. J., Strauss, N., Aghia, J., White, R. D., & Oleske, K. W. (2026). A passive MEMS check valve for an isolated micro pressure vessel and micro-stirling engine development. Journal of Micromechanics and Microengineering. https://doi.org/10.1088/1361-6439/aec459
Vancouver
Cheng TJ, Strauss N, Aghia J, White RD, Oleske KW. A passive MEMS check valve for an isolated micro pressure vessel and micro-stirling engine development. Journal of Micromechanics and Microengineering. 2026. doi:10.1088/1361-6439/aec459
BibTeX
@article{Cheng2026,
author = {Cheng, Timothy James and Strauss, Nancy and Aghia, Joseph and White, Robert D and Oleske, Katherine W.},
title = {A passive MEMS check valve for an isolated micro pressure vessel and micro-stirling engine development},
journal = {Journal of Micromechanics and Microengineering},
year = {2026},
doi = {10.1088/1361-6439/aec459}
}
EUVIMED