Analytic modeling of fluidic resistances inside of cantilever-based structures for microelectromechanical sensors and actuators
Journal of Micromechanics and Microengineering · 01.08.2026 · 36 (8) · 085009
DOI: 10.1088/1361-6439/ae8863 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Micromechanics and Microengineering, online erschienen am 12.08.2026. Verfasst von Christian Görner Tenorio und 6 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
Acoustic microelectromechanical sensors and actuators like microphones or microspeakers often use cantilever-based structures. The fluidic resistance due to the air slit between the cantilevers plays a crucial role for acoustic key parameters like the low-frequency roll-off or the sound pressure level of such device. The opening and closing behavior of such air slits becomes complex when the displacement profile of the cantilevers is considered, leading to nonuniform slit openings, slit widths and Knudsen number-based corrections for the airflow resistance along the cantilever arc length. To extract the fluidic resistances of the air slits, the application of finite element methods (FEMs) is necessary. However, such methods require time-consuming simulations, which make the design of acoustic microelectromechanical system devices cumbersome. Using a physics-based analytic model can mitigate the computational efforts by extracting fluidic resistances utilizing microfluidic equations. The here presented model uses various geometric cantilever parameters in combination with discretizing the fluidic slit resistance along the arc length of the cantilever to calculate the fluidic resistance for each displacement. The model considers rarefied gases for small air slits of 500 nm as well as static prebending induced by e.g. residual mechanical stress in fabrication processes. A four-flap triangular cantilever structure is used to verify the derived physics-based analytic model with FEM simulations. The proposed model shows a good agreemend with the conducted FEM simulations over a large range of geometric parameters. In future work, it can be implemented in circuit simulators allowing a lumped element representation of the microphone or microspeaker.
Zitieren
APA
Tenorio, C. G., Anzinger, S., Bretthauer, C., Bogner, A., Timme, H., Heiss, H., & Schrag, G. (2026). Analytic modeling of fluidic resistances inside of cantilever-based structures for microelectromechanical sensors and actuators. Journal of Micromechanics and Microengineering, 36(8), 085009. https://doi.org/10.1088/1361-6439/ae8863
Vancouver
Tenorio CG, Anzinger S, Bretthauer C, Bogner A, Timme H, Heiss H, et al. Analytic modeling of fluidic resistances inside of cantilever-based structures for microelectromechanical sensors and actuators. Journal of Micromechanics and Microengineering. 2026;36(8):085009. doi:10.1088/1361-6439/ae8863
BibTeX
@article{Tenorio2026,
author = {Tenorio, Christian Görner and Anzinger, Sebastian and Bretthauer, Christian and Bogner, Andreas and Timme, Hans-Jörg and Heiss, Heinrich and Schrag, Gabriele},
title = {Analytic modeling of fluidic resistances inside of cantilever-based structures for microelectromechanical sensors and actuators},
journal = {Journal of Micromechanics and Microengineering},
year = {2026},
volume = {36},
number = {8},
pages = {085009},
doi = {10.1088/1361-6439/ae8863}
}
EUVIMED