Vortex control in a jet-mixing tank of automotive manufacturing
Physics of Fluids · 01.05.2026 · 38 (5)
DOI: 10.1063/5.0320789 ↗Kurz gefasst
Fachartikel in der Zeitschrift Physics of Fluids, online erschienen am 04.05.2026. Verfasst von Joana Matos und 7 weiteren Autor:innen. Die Arbeit nennt 37 Literaturangaben. Gefördert von: Recovery and Resilience Plan of the European Union, Fundacao para a Computacao Cientifica Nacional, Fundacao para a Ciencia e Tecnologia, I.P. /MCTES.
Abstract (Originalsprache)
Chaotic recirculating flows in jet-mixing tanks can be controlled via vortex-jet interactions through topology modifications. For the case study of an automotive cleaning tank, the flow enters through an injection plenum and exits through a suction plenum. In Part 1, the diameter of the collector ports and the overall topology of the plenums were analyzed with computational fluid dynamics. Four configurations were compared: velocity, recirculation flow rate, and shear stress, which should be maximized to improve cleaning, and the vortice size, which should be minimized to uniformize impurities removal. For a parallelepiped tank, the best results are achieved with symmetric plenums and a collector close to the edge wall, behind the injectors. The collector should be positioned in the injector plane to enable a full circulation before the suction. The ports should have an angle of 90° to the injectors, easing the suction. The same flow rate must be removed by each port. It was possible to increase the velocity in 9%, the recirculation flow rate in 22%, and the shear stress in 36%. In Part 2, the cleaning was simulated with a car shell inside the best configuration. Compared to the original case, the velocities increased 30%, and the average shear stress increased 50%. Overall, it was shown that the jet-suction interaction is mainly responsible for the promotion of the recirculation flow rate, and collector modifications have a major influence on the suction system. The use of symmetry influences the size of vortices and flow uniformization.
Förderung
- Recovery and Resilience Plan of the European Union
- Fundacao para a Computacao Cientifica Nacional
- Fundacao para a Ciencia e Tecnologia, I.P. /MCTES
Zitieren
APA
Matos, J., Lorenzoni, N., Gomes, C., Domingos, M. G., Sales, A. P., Pereira, P. S., Cardoso, A., & Lopes, J. C. B. (2026). Vortex control in a jet-mixing tank of automotive manufacturing. Physics of Fluids, 38(5). https://doi.org/10.1063/5.0320789
Vancouver
Matos J, Lorenzoni N, Gomes C, Domingos MG, Sales AP, Pereira PS, et al. Vortex control in a jet-mixing tank of automotive manufacturing. Physics of Fluids. 2026;38(5). doi:10.1063/5.0320789
BibTeX
@article{Matos2026,
author = {Matos, Joana and Lorenzoni, Nelson and Gomes, Carla and Domingos, Mariana G. and Sales, Ana Paula and Pereira, Paulo S. and Cardoso, Alexandre and Lopes, José Carlos B.},
title = {Vortex control in a jet-mixing tank of automotive manufacturing},
journal = {Physics of Fluids},
year = {2026},
volume = {38},
number = {5},
doi = {10.1063/5.0320789}
}
EUVIMED