Halide vapor phase epitaxy of a thick c -plane α-Ga2O3 film on a high-quality α-Cr2O3/sapphire template
Journal of Applied Physics · 21.02.2026 · 139 (7)
DOI: 10.1063/5.0319104 ↗Kurz gefasst
Fachartikel in der Zeitschrift Journal of Applied Physics, online erschienen am 17.02.2026. Verfasst von Yuichi Oshima und 5 weiteren Autor:innen. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).
Abstract (Originalsprache)
α-Ga2O3 is a promising ultra-wide-bandgap semiconductor for future power devices, and the use of α-Cr2O3 buffer layers represents an effective approach to improve the crystalline quality of heteroepitaxial α-Ga2O3 films owing to the small lattice mismatch between the two materials. In this study, c-plane α-Ga2O3 films were grown using halide vapor phase epitaxy (HVPE) on high-quality α-Cr2O3/sapphire templates, and the dependence of crystalline quality on the film thickness was systematically investigated. HVPE growth was performed under atmospheric pressure at 520 °C using GaCl and O2 as the precursors and at a growth rate of 14 μm h−1. The film thickness was varied from 0.24 to 21 μm by controlling the growth time. X-ray 2θ–ω scan and pole figure measurements helped confirm that the α-Ga2O3 epilayers were phase-pure single-crystalline films. Thickness-dependent x-ray rocking curve measurements and reciprocal space mapping revealed that lattice relaxation began at a thickness of approximately 0.47 μm or less and virtually completed at thicknesses of 11 μm or greater. Cross-sectional scanning transmission electron microscopy results showed that dislocations were observed predominantly near the film surface and were absent at the α-Ga2O3/α-Cr2O3 interface. Etch-pit density measurements yielded a low dislocation density of 5.6 × 107 cm−2 for the fully strained 0.24 μm-thick film. The almost fully relaxed 21 μm-thick film showed a higher dislocation density of 3.9 × 108 cm−2. Nevertheless, this value was approximately one order of magnitude lower than that of an α-Ga2O3 film directly grown on a c-plane sapphire substrate under identical conditions.
Zitieren
APA
Oshima, Y., Oshima, T., Xiao, S., Murakami, K., Imai, K., & Tomita, T. (2026). Halide vapor phase epitaxy of a thick c -plane α-Ga2O3 film on a high-quality α-Cr2O3/sapphire template. Journal of Applied Physics, 139(7). https://doi.org/10.1063/5.0319104
Vancouver
Oshima Y, Oshima T, Xiao S, Murakami K, Imai K, Tomita T. Halide vapor phase epitaxy of a thick c -plane α-Ga2O3 film on a high-quality α-Cr2O3/sapphire template. Journal of Applied Physics. 2026;139(7). doi:10.1063/5.0319104
BibTeX
@article{Oshima2026,
author = {Oshima, Yuichi and Oshima, Takayoshi and Xiao, Shiyu and Murakami, Kazuto and Imai, Katsuhiro and Tomita, Takahiro},
title = {Halide vapor phase epitaxy of a thick c -plane α-Ga2O3 film on a high-quality α-Cr2O3/sapphire template},
journal = {Journal of Applied Physics},
year = {2026},
volume = {139},
number = {7},
doi = {10.1063/5.0319104}
}
EUVIMED