EUVIMEDEUVIMED entdecken
Crossref

Optimizing thermoelectric efficiency in Sn-doped Sb2Te3 alloys through Se alloying by modulating carrier and phonon transport

Gyujin Chang iD, Chanwoo Ju iD, GwanHyeong Lee, Jaewoo Park, Seungwoo Ha, Yunjae Kim, Sang-Il Kim iD

The Journal of Chemical Physics · 21.10.2025 · 163 (15)

DOI: 10.1063/5.0293730 ↗

Kurz gefasst

Fachartikel in der Zeitschrift The Journal of Chemical Physics, online erschienen am 20.10.2025. Verfasst von Gyujin Chang und 6 weiteren Autor:innen. Beteiligte Einrichtung: Department of Materials Science and Engineering, University of Seoul, Seoul 02504, South Korea. Die Arbeit wurde bisher 3-mal zitiert (Crossref) und nennt 35 Literaturangaben. Gefördert von: National Research Foundation of Korea.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Sb2Te3-based alloys have attracted considerable attention owing to their favorable thermoelectric transport properties in the mid-temperature range. Herein, the thermoelectric transport properties of pristine Sb2Te3 and Sn0.03Sb1.97Te3–ySey (y = 0, 0.05, 0.10, 0.15, 0.20, and 0.25) alloys were systematically investigated by combining Sn doping with Se alloying. The 1.5 at. % Sn doping in Sb2Te3 as Sn0.03Sb1.97Te3 increased the density-of-states effective mass (md*) and reduced lattice thermal conductivity (κlatt) compared with those of Sb2Te3, thereby enhancing the maximum thermoelectric figure of merit to 0.58 from 0.46. However, it also significantly increased the carrier concentration (nH) to 1.46 × 1020 cm−3, thereby limiting further enhancement of the thermoelectric figure of merit (zT). Se alloying was introduced to reduce nH by suppressing the native antisite defects. With Se alloying, nH gradually decreased, as expected; however, a concurrent slight reduction in md* was observed and, therefore, further increase in power factor was limited. Nevertheless, Se alloying led to a rather large reduction in total thermal conductivity owing to reductions in both electronic and lattice thermal conductivities induced by nH decrease and additional phonon scattering, respectively. Consequently, the overall zT increased with a small amount of Se alloying up to y = 0.10, with a maximum zT of 0.67 at 650 K, compared with 0.46 of Sb2Te3 and 0.59 of Sn0.03Sb1.97Te3. This study demonstrated that the dual doping or further alloying of the doped compositions could be effective, as it leads to a rather large reduction in thermal conductivity despite a potential slight decrease in enhanced md* owing to mobility degradation.

Autor:innen und Institutionen

  • Department of Materials Science and Engineering, University of Seoul, Seoul 02504, South Korea.

ORCID-Profile: Gyujin Chang, Chanwoo Ju, Sang-Il Kim

Förderung

  • National Research Foundation of Korea

Zitieren

APA

Chang, G., Ju, C., Lee, G., Park, J., Ha, S., Kim, Y., & Kim, S. I. (2025). Optimizing thermoelectric efficiency in Sn-doped Sb2Te3 alloys through Se alloying by modulating carrier and phonon transport. The Journal of Chemical Physics, 163(15). https://doi.org/10.1063/5.0293730

Vancouver

Chang G, Ju C, Lee G, Park J, Ha S, Kim Y, et al. Optimizing thermoelectric efficiency in Sn-doped Sb2Te3 alloys through Se alloying by modulating carrier and phonon transport. The Journal of Chemical Physics. 2025;163(15). doi:10.1063/5.0293730

BibTeX
@article{Chang2025,
  author = {Chang, Gyujin and Ju, Chanwoo and Lee, GwanHyeong and Park, Jaewoo and Ha, Seungwoo and Kim, Yunjae and Kim, Sang-Il},
  title = {Optimizing thermoelectric efficiency in Sn-doped Sb2Te3 alloys through Se alloying by modulating carrier and phonon transport},
  journal = {The Journal of Chemical Physics},
  year = {2025},
  volume = {163},
  number = {15},
  doi = {10.1063/5.0293730}
}
Kostenlos starten →