EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effect of magnetron sputtering process parameters on the conductivity of thin metal film

Shuangjie Liu, Xingwang Li, Yongping Hao, Xing Li, Fengli Liu

AIP Advances · 01.09.2023 · 13 (9)

DOI: 10.1063/5.0170746 ↗

Kurz gefasst

Fachartikel in der Zeitschrift AIP Advances, online erschienen am 29.09.2023. Verfasst von Shuangjie Liu und 4 weiteren Autor:innen. Die Arbeit wurde bisher 10-mal zitiert (Crossref) und nennt 23 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Department of Education of Liaoning Province, Shenyang Ligong University.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper focuses on the effect of magnetron sputtering process parameters on the performance of thin metal film. Copper–tin alloy metal film was deposited on both sides of the PVDF film using direct current magnetron sputtering technology, and the effects of different working pressures, sputtering powers, sputtering times, and argon flow rates on the uniformity, deposition rate, and electrical conductivity of the metal film were studied separately. The main and minor factors affecting the conductivity of the metal film were determined by multiple linear regression, and the process parameters were optimized. The optimal process parameters include a working pressure of 0.065 Pa, a sputtering power of 70 W, a sputtering time of 20 min, and an argon flow of 20 SCCM. The samples with the best electrical conductivity were analyzed by scanning electron microscopy and energy spectrometry for microscopic morphology and elemental composition. The experimental results showed that the sputtering time and sputtering power have a greater effect on the metal film uniformity and that the working pressure and argon flow rate have a smaller effect on the metal film uniformity; when the working pressure is lower, the sputtering power is higher, the sputtering time is longer, the argon flow rate is higher, and the conductivity of the sputtered metal film is better. The deposition rate decreased with the increase in the working pressure and increased with the increase in the sputtering power and argon flow rate. The working pressure is the main factor affecting the conductivity of the metal film, and the sputtering power and sputtering time are secondary factors.

Förderung

  • Department of Education of Liaoning Province
  • Shenyang Ligong University

Zitieren

APA

Liu, S., Li, X., Hao, Y., Li, X., & Liu, F. (2023). Effect of magnetron sputtering process parameters on the conductivity of thin metal film. AIP Advances, 13(9). https://doi.org/10.1063/5.0170746

Vancouver

Liu S, Li X, Hao Y, Li X, Liu F. Effect of magnetron sputtering process parameters on the conductivity of thin metal film. AIP Advances. 2023;13(9). doi:10.1063/5.0170746

BibTeX
@article{Liu2023,
  author = {Liu, Shuangjie and Li, Xingwang and Hao, Yongping and Li, Xing and Liu, Fengli},
  title = {Effect of magnetron sputtering process parameters on the conductivity of thin metal film},
  journal = {AIP Advances},
  year = {2023},
  volume = {13},
  number = {9},
  doi = {10.1063/5.0170746}
}
Infokarte | EUVIMED

Artikeldaten derzeit nicht verfügbar.

Recherche