EUVIMEDEUVIMED entdecken
Crossref

Fabrication of titanium–steel joints with a copper powder interlayer by electro-assisted hot pressing

Cheng-Min Song, Chun-Lin Peng, De-Li Shang, Xiang-Wei Liao, Guo-Hua Zhang, Kuo-Chih Chou

Metallurgical Research & Technology · 2026 · 123 (3) · 326

DOI: 10.1051/metal/2026025 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Metallurgical Research & Technology, online erschienen am 27.03.2026. Verfasst von Cheng-Min Song und 5 weiteren Autor:innen. Die Arbeit nennt 33 Literaturangaben. Gefördert von: State Key Laboratory of Advanced Metallurgy.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this study, the electro-assisted hot pressing technique was utilized to join low-alloy steel and commercially pure titanium by employing copper powder as an interlayer under an axial load of 20 MPa within a temperature range of 550 °C to 750 °C. The growth mechanism of intermetallic phases at the titanium/copper interface was investigated using scanning and transmission electron microscopy, X-ray diffraction, and mechanical testing. The correlation between the evolution of Cu–Ti compounds and copper content was clarified through thermodynamic analysis. The results indicate that under rapid heating conditions, the continuity of the copper powder layer was disrupted; however, it formed a mechanically interlocked structure with the titanium substrate. A maximum shear strength of approximately 172.6 MPa was achieved at 750 °C, corresponding to about 72.6% of the shear strength of pure copper.

Förderung

  • State Key Laboratory of Advanced Metallurgy

Zitieren

APA

Song, C., Peng, C., Shang, D., Liao, X., Zhang, G., & Chou, K. (2026). Fabrication of titanium–steel joints with a copper powder interlayer by electro-assisted hot pressing. Metallurgical Research & Technology, 123(3), 326. https://doi.org/10.1051/metal/2026025

Vancouver

Song C, Peng C, Shang D, Liao X, Zhang G, Chou K. Fabrication of titanium–steel joints with a copper powder interlayer by electro-assisted hot pressing. Metallurgical Research & Technology. 2026;123(3):326. doi:10.1051/metal/2026025

BibTeX
@article{Song2026,
  author = {Song, Cheng-Min and Peng, Chun-Lin and Shang, De-Li and Liao, Xiang-Wei and Zhang, Guo-Hua and Chou, Kuo-Chih},
  title = {Fabrication of titanium–steel joints with a copper powder interlayer by electro-assisted hot pressing},
  journal = {Metallurgical Research & Technology},
  year = {2026},
  volume = {123},
  number = {3},
  pages = {326},
  doi = {10.1051/metal/2026025}
}
Kostenlos starten →