EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Decomposition analysis and peak stagger design for Crank-triangular linkage-elbow mechanism of mechanical servo presses

Yousong Sun, Jianguo Hu, Liangmo Wei, Yongqi Chen

Mechanics & Industry · 2021 · 22 · 43

DOI: 10.1051/meca/2021042 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Mechanics & Industry, online erschienen am 06.10.2021. Verfasst von Yousong Sun und 3 weiteren Autor:innen. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 34 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

High mechanical advantage as well as low and steady slide speed within the working stroke S n are the fundamental requirements for the working mechanism of servo-mechanical press. Currently, the Crank-Triangular Linkage-Elbow (CTLE) mechanism has attracted more and more attention from researchers and manufacturers of servo presses. This paper presents a new analysis and design method of CTLE. The mechanism is decomposed into two sub-units: crank and triangular-linkage elbow, followed by the kinematic and force analysis of each sub-unit. The influences of each structural parameter on the working performance are obtained and can be used as the basis for preliminary design. Through the offset design, the mechanical advantage peaks of the two units, MA 1max and MA 2max , do not occur at the same time: MA 1max is located near S n , while MA 2max is just at BDC (Bottom Dead Center). Because the mechanical advantage of the whole mechanism is the product of the two subunits, the designed mechanism can obtain high and steady mechanical advantage together with low and steady slide speed within S n . After preliminary design, the scheme can be further modified by numerical simulation and optimization. Hence the design efficiency can be improved.

Zitieren

APA

Sun, Y., Hu, J., Wei, L., & Chen, Y. (2021). Decomposition analysis and peak stagger design for Crank-triangular linkage-elbow mechanism of mechanical servo presses. Mechanics & Industry, 22, 43. https://doi.org/10.1051/meca/2021042

Vancouver

Sun Y, Hu J, Wei L, Chen Y. Decomposition analysis and peak stagger design for Crank-triangular linkage-elbow mechanism of mechanical servo presses. Mechanics & Industry. 2021;22:43. doi:10.1051/meca/2021042

BibTeX
@article{Sun2021,
  author = {Sun, Yousong and Hu, Jianguo and Wei, Liangmo and Chen, Yongqi},
  title = {Decomposition analysis and peak stagger design for Crank-triangular linkage-elbow mechanism of mechanical servo presses},
  journal = {Mechanics & Industry},
  year = {2021},
  volume = {22},
  pages = {43},
  doi = {10.1051/meca/2021042}
}
Kostenlos starten →