Optimizing binaural cue measurement for an acoustic test fixture using a 3D-head shell
Acta Acustica · 2026 · 10 · 69
DOI: 10.1051/aacus/2026072 ↗Kurz gefasst
Fachartikel in der Zeitschrift Acta Acustica, online erschienen am 24.07.2026. Verfasst von Sina Buchholz und 2 weiteren Autor:innen. Die Arbeit nennt 28 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Deutsche Gesetzliche Unfallversicherung.
Abstract (Originalsprache)
Although artificial heads based on the human anatomy are typically used to measure binaural cues in various scenarios, they usually do not provide sufficient acoustic insulation that becomes important, e.g., when measuring at low frequencies or with hearing protectors. For these purposes, an acoustic test fixture (ATF) with high acoustic insulation should be used. However, such ATFs do not reflect the human anatomy, which may affect measurements of binaural cues and other spatially separated sounds. This study investigated differences in interaural time and level differences measured with an artificial head with human anatomy and the GRAS ATF 45CA. The measurements took place inside an anechoic chamber with a circular array of 48 loudspeakers. Moreover, a mountable head consisting of two 3D-printed shells for the ATF based on a KEMAR head was designed to approximate plausible head anatomy while preserving the advantages of an ATF. Binaural cues were also measured with the ATF and attached head shells. The results indicate that differences in binaural cues between the artificial head and ATF largely depend on incident angle and frequency. The differences could be reduced with the additional head shells which make them a reasonable add-on for the ATF when measuring binaural cues.
Förderung
- Deutsche Gesetzliche Unfallversicherung
Zitieren
APA
Buchholz, S., Vogl, S., & Rennies, J. (2026). Optimizing binaural cue measurement for an acoustic test fixture using a 3D-head shell. Acta Acustica, 10, 69. https://doi.org/10.1051/aacus/2026072
Vancouver
Buchholz S, Vogl S, Rennies J. Optimizing binaural cue measurement for an acoustic test fixture using a 3D-head shell. Acta Acustica. 2026;10:69. doi:10.1051/aacus/2026072
BibTeX
@article{Buchholz2026,
author = {Buchholz, Sina and Vogl, Steffen and Rennies, Jan},
title = {Optimizing binaural cue measurement for an acoustic test fixture using a 3D-head shell},
journal = {Acta Acustica},
year = {2026},
volume = {10},
pages = {69},
doi = {10.1051/aacus/2026072}
}
EUVIMED