EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

High step‐up direct ac‐ac boost converter with optimal component counts based on SEPIC

Alireza Lahooti Eshkevari, Iman Abdoli, Mostafa Karimi Hajiabadi, Ali Mosallanejad

IET Power Electronics · 2024-07 · 17 (9) · 1106-1118

DOI: 10.1049/pel2.12644 ↗

Kurz gefasst

Fachartikel in der Zeitschrift IET Power Electronics, online erschienen am 02.01.2024. Verfasst von Alireza Lahooti Eshkevari und 3 weiteren Autor:innen. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 37 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0).

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

This paper introduces a new direct step‐up ac‐ac converter designed based on the SEPIC. It provides a higher step‐up conversion ratio than other counterparts with valuable features like high efficiency, reasonable input and output total harmonic distortions (THD), continuous input current waveform, common ground, few components, and single‐stage conversion without snubber and LC filters. Unlike most counterparts, the duty cycle can be varied between zero and one in boost operation and is not limited to any value below one. The voltage stress on one switch is reduced by increasing the winding coefficient of the utilized coupled inductor, and current stress on another is independent of this coefficient. It reduces the switches' losses and improves the converter efficiency. Thanks to the above attributes, the proposed converter is suitable for inductive power transfer from low‐voltage ac sources, operating as an ac voltage regulator for sensitive ac loads, and any applications that require a boost converter with few components. This article shows the converter's operation principle and evaluates its performance through experiments on a 225 W prototype. Accordingly, the maximum obtained efficiency is 95.4%. The input and output current THDs for the nominal inductive load equal 4.5 and 2.8%, respectively. Results confirm the claims.

Zitieren

APA

Eshkevari, A. L., Abdoli, I., Hajiabadi, M. K., & Mosallanejad, A. (2024). High step‐up direct ac‐ac boost converter with optimal component counts based on SEPIC. IET Power Electronics, 17(9), 1106-1118. https://doi.org/10.1049/pel2.12644

Vancouver

Eshkevari AL, Abdoli I, Hajiabadi MK, Mosallanejad A. High step‐up direct ac‐ac boost converter with optimal component counts based on SEPIC. IET Power Electronics. 2024;17(9):1106-1118. doi:10.1049/pel2.12644

BibTeX
@article{Eshkevari2024,
  author = {Eshkevari, Alireza Lahooti and Abdoli, Iman and Hajiabadi, Mostafa Karimi and Mosallanejad, Ali},
  title = {High step‐up direct ac‐ac boost converter with optimal component counts based on SEPIC},
  journal = {IET Power Electronics},
  year = {2024},
  volume = {17},
  number = {9},
  pages = {1106--1118},
  doi = {10.1049/pel2.12644}
}
Kostenlos starten →