EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

High Performance in the Piezocatalytic Reduction of p -Nitrophenol to p -Aminophenol Using Li1– x Cu x NbO3 Synthesized by the Modified Pechini Method

Wanison André Gil Pessoa Júnior, Ingrity Suelen Costa Sá, Francisco Marcos Costa Batista, Daniel Pais Ospina, David Comedi, Monica Tirado, Nadia Celeste Vega, Oscar Marin-Ramirez, Yurimiler Leyet Ruiz, Francisco Xavier Nobre, Paulo Rogério da Costa Couceiro

ACS Physical Chemistry Au · 29.10.2026

DOI: 10.1021/acsphyschemau.6c00171 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Physical Chemistry Au, online erschienen am 29.10.2026. Verfasst von Wanison André Gil Pessoa Júnior und 10 weiteren Autor:innen. Die Arbeit nennt 84 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Fundação de Amparo à Pesquisa do Estado do Amazonas, Conselho Nacional de Desenvolvimento Científico e Tecnológico, Coordenação de Aperfeiçoamento de Pessoal de Nível Superior.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The development of efficient catalysts for environmental remediation and the conversion of chemical compounds into value-added products remains an important challenge in materials science. Herein, Cu-doped lithium niobate (Li1–xCuxNbO3; 0 ≤ x ≤ 0.025) was synthesized by a modified sol–gel method followed by heat treatment at 500 °C for 2 h. X-ray diffraction and Raman spectroscopy confirmed the predominant formation of trigonal LiNbO3 (R–3c), together with less than 5% monoclinic CuNb2O6 (P21/c) as a secondary phase in the doped samples. Cu incorporation enhanced visible-light absorption and decreased the optical bandgap from 3.95 eV for pure LiNbO3 to 2.96 eV for the x = 0.025 composition, likely owing to the introduction of intermediate electronic states. X-ray photoelectron spectroscopy confirmed the expected Li, Nb, O, and Cu surface chemical states. The materials were evaluated as piezocatalysts for the reduction of p-nitrophenol (PNP), mainly to p-aminophenol (PAP), which was supported by UV–vis and 1H NMR analyses. Cu-doped samples achieved PNP reduction above 93% within 5 min and retained this performance after four reuse cycles, whereas pure LiNbO3 exhibited conversion below 20%. Scavenger experiments indicated that electrons were the primary charge carriers involved in the reaction. These findings demonstrate that Cu-doped LiNbO3 is a promising reusable piezocatalyst for the rapid conversion of PNP under ambient conditions.

Förderung

  • Fundação de Amparo à Pesquisa do Estado do Amazonas
  • Conselho Nacional de Desenvolvimento Científico e Tecnológico
  • Coordenação de Aperfeiçoamento de Pessoal de Nível Superior

Zitieren

APA

Júnior, W. A. G. P., Sá, I. S. C., Batista, F. M. C., Ospina, D. P., Comedi, D., Tirado, M., Vega, N. C., Marin-Ramirez, O., Ruiz, Y. L., Nobre, F. X., & Couceiro, P. R. D. C. (2026). High Performance in the Piezocatalytic Reduction of p -Nitrophenol to p -Aminophenol Using Li1– x Cu x NbO3 Synthesized by the Modified Pechini Method. ACS Physical Chemistry Au. https://doi.org/10.1021/acsphyschemau.6c00171

Vancouver

Júnior WAGP, Sá ISC, Batista FMC, Ospina DP, Comedi D, Tirado M, et al. High Performance in the Piezocatalytic Reduction of p -Nitrophenol to p -Aminophenol Using Li1– x Cu x NbO3 Synthesized by the Modified Pechini Method. ACS Physical Chemistry Au. 2026. doi:10.1021/acsphyschemau.6c00171

BibTeX
@article{Junior2026,
  author = {Júnior, Wanison André Gil Pessoa and Sá, Ingrity Suelen Costa and Batista, Francisco Marcos Costa and Ospina, Daniel Pais and Comedi, David and Tirado, Monica and Vega, Nadia Celeste and Marin-Ramirez, Oscar and Ruiz, Yurimiler Leyet and Nobre, Francisco Xavier and Couceiro, Paulo Rogério da Costa},
  title = {High Performance in the Piezocatalytic Reduction of p -Nitrophenol to p -Aminophenol Using Li1– x Cu x NbO3 Synthesized by the Modified Pechini Method},
  journal = {ACS Physical Chemistry Au},
  year = {2026},
  doi = {10.1021/acsphyschemau.6c00171}
}
Kostenlos starten →