Quantitative Characterization and Flow Simulation of Micropore Structure in Clastic Gas Reservoirs Based on Micron CT Scanning
ACS Omega · 27.05.2025 · 10 (20) · 20686-20700
DOI: 10.1021/acsomega.5c01569 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Omega, online erschienen am 14.05.2025. Verfasst von Jiaming Liu und 4 weiteren Autor:innen. Beteiligte Einrichtung: College of Petroleum Engineering, Xi'an Shiyou University, Xi'an, Shaanxi 710065, China. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 32 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Key Research and Development Projects of Shaanxi Province.
Abstract (Originalsprache)
This study employed high-resolution CT scanning and Avizo software algorithms to analyze the microscopic pore structure of the clastic rock reservoir in the Yingcheng Formation, Block D, southeastern Songliao Basin, China, and its impact on fluid flow, constructing a high-precision three-dimensional digital rock model. The optimal representative elementary volume (REV) was identified as 400 × 400 × 400 voxels. Using this as a basis, the ″maximum ball″ algorithm extracted the pore network model, allowing for quantitative characterization of its topological features and PNM-based single-phase flow simulations. Furthermore, two-phase flow simulations of CO2 displacing CH4 were performed via the AVIZO-FLUENT interactive coupling technology. Results show that the reservoir exhibits significant heterogeneity, with pore radii mainly between 2 and 7 μm and throat radii from 0.5 to 3 μm, reflecting a typical ″large pore, small throat″ characteristic. Throat lengths are primarily between 10 and 25 μm, while the coordination number is mainly within 1-4. Permeability correlates positively with pore-throat radius and throat length but negatively with tortuosity and fractal dimension. Single-phase flow simulations indicate that pore structure complexity significantly affects seepage behavior. The numerically simulated permeability deviates from experimental measurements by no more than 12.5%, confirming the reliability of the simulation approach. Two-phase flow simulations show that the CO2 displacement is significantly affected by pore structure complexity and heterogeneity, progressing through three stages: uniform front advancement, fingering development, and residual gas retention. Residual CH4 mainly accumulates at pore edges and corners, with final CO2 and residual CH4 saturations stabilizing at 94.74 and 5.26%, respectively. Integrating digital rock technology with multiscale flow simulations, this study refines the characterization of complex reservoir pore structures and elucidates their control over fluid migration. These findings provide a scientific basis for optimizing CO2 geological storage and enhancing gas reservoir recovery while also supporting development strategies for low-permeability reservoirs.
Autor:innen und Institutionen
- College of Petroleum Engineering, Xi'an Shiyou University, Xi'an, Shaanxi 710065, China.
- PetroChina Jilin Oilfield Company Exploration and Development Research Institute, Songyuan, Jilin 138000, China.
ORCID-Profile: Jiaming Liu
Förderung
- Key Research and Development Projects of Shaanxi Province
Zitieren
APA
Liu, J., Wang, R., Song, P., Li, Y., & Zheng, S. (2025). Quantitative Characterization and Flow Simulation of Micropore Structure in Clastic Gas Reservoirs Based on Micron CT Scanning. ACS Omega, 10(20), 20686-20700. https://doi.org/10.1021/acsomega.5c01569
Vancouver
Liu J, Wang R, Song P, Li Y, Zheng S. Quantitative Characterization and Flow Simulation of Micropore Structure in Clastic Gas Reservoirs Based on Micron CT Scanning. ACS Omega. 2025;10(20):20686-20700. doi:10.1021/acsomega.5c01569
BibTeX
@article{Liu2025,
author = {Liu, Jiaming and Wang, Ruifei and Song, Peng and Li, Yutong and Zheng, Sen},
title = {Quantitative Characterization and Flow Simulation of Micropore Structure in Clastic Gas Reservoirs Based on Micron CT Scanning},
journal = {ACS Omega},
year = {2025},
volume = {10},
number = {20},
pages = {20686--20700},
doi = {10.1021/acsomega.5c01569}
}
EUVIMED