Bismuth Ferrite–Silver Nanowire Flexible Nanocomposites for Room-Temperature Nitrogen Dioxide Sensing
ACS Omega · 02.07.2024 · 9 (26) · 28978-28988
DOI: 10.1021/acsomega.4c04076 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Omega, online erschienen am 22.06.2024. Verfasst von Sanjeev Patil und 2 weiteren Autor:innen. Beteiligte Einrichtung: Electronic Materials and Thin Films Lab, Department of Metallurgical and Materials Engineering, IIT Madras, Chennai 600036, India. Die Arbeit wurde bisher 20-mal zitiert (Crossref) und nennt 67 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Indian Institute of Technology Madras.
Abstract (Originalsprache)
Nitrogen dioxide (NO2) is a major pollutant, causing acid rain, photochemical smog, and respiratory damage. The annual safe limit is 50 parts per billion (ppb), while concentrations exceeding 1 part per million (ppm) can result in respiratory ailments. Conventionally, n-type metal oxide semiconductors operating at elevated temperatures have been utilized for NO2 detection. Recently, p-type semiconductors with their hole accumulation layer, rapid recovery post-gas exposure, and good humidity tolerance are being investigated as potential NO2 sensors, once again working at elevated temperatures. In this work, a room-temperature (27 ± 2 °C) NO2 sensor is demonstrated by using a nanocomposite based on p-type bismuth ferrite (BFO) nanoparticles and silver nanowires (Ag NWs). This nanocomposite is capable of sensing a NO2 gas concentration of up to 0.2 ppm. The BFO nanoparticles are synthesized via a sol-gel route followed by sintering at 500 °C to form the crystalline phase. Nanocomposites are obtained by formulating a dispersion of the BFO nanoparticles and Ag NWs, followed by direct writing on both flexible and rigid substrates. The Ag NWs act as the conducting pathway, reducing the overall electrical resistance and thus enabling room-temperature operation. X-ray diffraction, scanning electron microscopy, and surface area studies provide phase information and surface morphology, and the porous nature of the film helps in room-temperature gas adsorption. The current-voltage and gas-sensing behavior are studied to obtain the optimized molar ratio (4:1 BFO/Ag NWs) for the sensor. The sensor deposited on poly(ethylene terephthalate) (PET) also works under a bent condition, indicating good flexibility. Rapid NO2 sensing was achieved in a BFO-Ag/PET device with response/recovery times of 7/8.5 s and 12/15 s in straight and bent geometries, respectively. Additionally, a good sensitivity of 30 to 60% was achieved for the BFO-Ag/PET device across 100 to 1000 ppb of NO2. The development of a nanocomposite combining an active sensing element (BFO) and a charge-transport element (Ag NWs) opens up a multitude of other application areas.
Autor:innen und Institutionen
- Electronic Materials and Thin Films Lab, Department of Metallurgical and Materials Engineering, IIT Madras, Chennai 600036, India.
- Centre of Excellence in Ceramics Technologies for Futuristic Mobility, IIT Madras, Chennai 600036, India.
ORCID-Profile: Parasuraman Swaminathan
Förderung
- Indian Institute of Technology Madras
Zitieren
APA
Patil, S., Arumugam, S., & Swaminathan, P. (2024). Bismuth Ferrite–Silver Nanowire Flexible Nanocomposites for Room-Temperature Nitrogen Dioxide Sensing. ACS Omega, 9(26), 28978-28988. https://doi.org/10.1021/acsomega.4c04076
Vancouver
Patil S, Arumugam S, Swaminathan P. Bismuth Ferrite–Silver Nanowire Flexible Nanocomposites for Room-Temperature Nitrogen Dioxide Sensing. ACS Omega. 2024;9(26):28978-28988. doi:10.1021/acsomega.4c04076
BibTeX
@article{Patil2024,
author = {Patil, Sanjeev and Arumugam, Sudha and Swaminathan, Parasuraman},
title = {Bismuth Ferrite–Silver Nanowire Flexible Nanocomposites for Room-Temperature Nitrogen Dioxide Sensing},
journal = {ACS Omega},
year = {2024},
volume = {9},
number = {26},
pages = {28978--28988},
doi = {10.1021/acsomega.4c04076}
}
EUVIMED