Research on Component Variation and Factors Affecting Minimum Miscible Pressure in Low Viscosity Oil Miscibility Process
ACS Omega · 16.07.2024 · 9 (28) · 30131-30141
DOI: 10.1021/acsomega.3c08088 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Omega, online erschienen am 03.07.2024. Verfasst von Kun Yang und 5 weiteren Autor:innen. Beteiligte Einrichtung: State Key Laboratory of Petroleum Resources and Prospecting, China University of Petroleum (Beijing), Beijing 102249, China. Die Arbeit wurde bisher 12-mal zitiert (Crossref) und nennt 33 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: National Natural Science Foundation of China, National Key Research and Development Program of China.
Abstract (Originalsprache)
Miscible gas flooding is an important approach for enhancing the recovery of unconventional oil reservoirs. The injected gas and crude oil components has a significant impact on the minimum miscible pressure. In order to clarify the miscibility characteristics and factors influencing the minimum miscibility pressure, combining PVT and slim tube experiments, the minimum miscibility pressure between Tuha low viscosity oil and different injected gas was measured. Additionally, chromatography experiments were conducted to study the composition changes of produced oil. The results indicate that when the injection pressure is higher than the minimum miscible pressure, the extraction effect of injected gas on heavy fraction (C16+) in crude oil is enhanced and the extraction effect on light alkanes (C1–C6) is reduced. The increase in the content of light alkanes (C1–C6) and middle distillates (C7–C15) in crude oil reduces the minimum miscibility pressure between crude oil and injected gas. Pipeline gas can effectively extract heavy fraction from crude oil, but its breakthrough time is early. Under the same pressure, earlier breakthrough time of injected gas makes it more difficult for the crude oil and injected gas to miscible. Through the analysis of experimental results, the following main conclusions are drawn: Immiscible flooding causes heavy fraction (C16+) in crude oil to remain, which might affect the physical properties of the reservoir, increasing the difficulty of subsequent development. Gas fingering phenomenon significantly influences the miscibility of injected gas and crude oil, and the viscosity ratio of injected gas and crude oil under high-pressure conditions can be used as an important criterion for screening injected gas.
Autor:innen und Institutionen
- State Key Laboratory of Petroleum Resources and Prospecting, China University of Petroleum (Beijing), Beijing 102249, China.
- Research Institute of Exploration and Development, Tuha Oilfield Company, Petro China, Xinjiang 839009, China.
ORCID-Profile: Kun Yang, Shenglai Yang, Jiangtao Hu
Förderung
- National Natural Science Foundation of China
- National Key Research and Development Program of China
Zitieren
APA
Yang, K., Yang, S., Hu, J., Gao, Y., Liu, X., & Xiao, Z. (2024). Research on Component Variation and Factors Affecting Minimum Miscible Pressure in Low Viscosity Oil Miscibility Process. ACS Omega, 9(28), 30131-30141. https://doi.org/10.1021/acsomega.3c08088
Vancouver
Yang K, Yang S, Hu J, Gao Y, Liu X, Xiao Z. Research on Component Variation and Factors Affecting Minimum Miscible Pressure in Low Viscosity Oil Miscibility Process. ACS Omega. 2024;9(28):30131-30141. doi:10.1021/acsomega.3c08088
BibTeX
@article{Yang2024,
author = {Yang, Kun and Yang, Shenglai and Hu, Jiangtao and Gao, Yumeng and Liu, Xinyue and Xiao, Zhipeng},
title = {Research on Component Variation and Factors Affecting Minimum Miscible Pressure in Low Viscosity Oil Miscibility Process},
journal = {ACS Omega},
year = {2024},
volume = {9},
number = {28},
pages = {30131--30141},
doi = {10.1021/acsomega.3c08088}
}
EUVIMED