Development of Bronze Phase Titanium Dioxide Nanorods for Use as Fast-Charging Anode Materials in Lithium-Ion Batteries
ACS Omega · 02.05.2023 · 8 (17) · 15360-15370
DOI: 10.1021/acsomega.3c00618 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Omega, online erschienen am 20.04.2023. Verfasst von Korawith Pimta und 7 weiteren Autor:innen. Beteiligte Einrichtung: Department of Industrial Chemistry, Faculty of Science, Chiang Mai University, Chiang Mai 50200, Thailand. Die Arbeit wurde bisher 21-mal zitiert (Crossref) und nennt 72 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: Chiang Mai University, Office of National Higher Education Science Research and Innovation Policy Council, Murata Science Foundation.
Abstract (Originalsprache)
Bronze phase titanium dioxide (TiO2(B)) nanorods were successfully prepared via a hydrothermal method together with an ion exchange process and calcination by using anatase titanium dioxide precursors in the alkali hydrothermal system. TiO2 precursors promoted the elongation of nanorod morphology. The different hydrothermal temperatures and reaction times demonstrated that the synthesis parameters had a significant influence on phase formation and physical morphologies during the fabrication process. The effects of the synthesis conditions on the tailoring of the crystal morphology were discussed. The growth direction of the TiO2(B) nanorods was investigated by X-ray diffractometry (XRD) and scanning electron microscopy (SEM). The as-synthesized TiO2(B) nanorods obtained after calcination were used as anode materials and tested the efficiency of Li-ion batteries. This research will study the effects of particle morphologies and crystallinity of TiO2(B) derived from a modified hydrothermal method on the capacity and charging rate of the Li-ion battery. The TiO2(B) nanorods, which were synthesized by using a hydrothermal temperature of 220 °C for 12 h, presented excellent electrochemical performance with the highest Li storage capacity (348.8 mAh/g for 100 cycles at a current density of 100 mA/g) and excellent high-rate cycling capability (a specific capacity of 207.3 mAh/g for 1000 cycles at a rate of 5000 mA/g).
Autor:innen und Institutionen
- Department of Industrial Chemistry, Faculty of Science, Chiang Mai University, Chiang Mai 50200, Thailand.
- Center of Excellence in Materials Science and Technology, Chiang Mai University, Chiang Mai 50200, Thailand.
- Graduate School, Chiang Mai University, Chiang Mai 50200, Thailand.
- Department of Chemistry, Faculty of Science, Chiang Mai University, Chiang Mai 50200, Thailand.
- Institute for Chemical Research, Kyoto University, Uji 611-0011, Kyoto, Japan.
ORCID-Profile: Thanapat Autthawong, Mitsutaka Haruta, Hiroki Kurata, Thapanee Sarakonsri, Yothin Chimupala
Förderung
- Chiang Mai University
- Office of National Higher Education Science Research and Innovation Policy Council
- Murata Science Foundation
- Ministry of Higher Education, Science, Research and Innovation, Thailand
- Institute for Chemical Research, Kyoto University
Zitieren
APA
Pimta, K., Autthawong, T., Yodying, W., Phromma, C., Haruta, M., Kurata, H., Sarakonsri, T., & Chimupala, Y. (2023). Development of Bronze Phase Titanium Dioxide Nanorods for Use as Fast-Charging Anode Materials in Lithium-Ion Batteries. ACS Omega, 8(17), 15360-15370. https://doi.org/10.1021/acsomega.3c00618
Vancouver
Pimta K, Autthawong T, Yodying W, Phromma C, Haruta M, Kurata H, et al. Development of Bronze Phase Titanium Dioxide Nanorods for Use as Fast-Charging Anode Materials in Lithium-Ion Batteries. ACS Omega. 2023;8(17):15360-15370. doi:10.1021/acsomega.3c00618
BibTeX
@article{Pimta2023,
author = {Pimta, Korawith and Autthawong, Thanapat and Yodying, Waewwow and Phromma, Chitsanupong and Haruta, Mitsutaka and Kurata, Hiroki and Sarakonsri, Thapanee and Chimupala, Yothin},
title = {Development of Bronze Phase Titanium Dioxide Nanorods for Use as Fast-Charging Anode Materials in Lithium-Ion Batteries},
journal = {ACS Omega},
year = {2023},
volume = {8},
number = {17},
pages = {15360--15370},
doi = {10.1021/acsomega.3c00618}
}
EUVIMED