Near-Infrared–to–Visible Upconversion Sensitized by Conductive Films of PbS Quantum Dots
ACS Nano · 28.07.2026 · 20 (29) · 20688-20702
DOI: 10.1021/acsnano.6c05335 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Nano, online erschienen am 14.07.2026. Verfasst von Samihat Rahman und 6 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemistry, University of Toronto, Toronto, OntarioM5S 3H6, Canada. Die Arbeit nennt 105 Literaturangaben. Gefördert von: Canada Foundation for Innovation, Ontario Ministry of Research, Innovation and Science, University of Toronto.
Abstract (Originalsprache)
Photon upconversion via nanocrystal-sensitized triplet fusion is a photophysical process that converts two low-energy photons into one high-energy photon. Solid-state, near-infrared–to–visible upconversion has been previously demonstrated using bilayer devices incorporating lead sulfide (PbS) quantum dots (QDs) as the sensitizer. However, the potential light-harvesting ability of previous architectures is limited by the short exciton diffusion lengths in QD films with long, insulating, native ligands. Here we demonstrate near-infrared–to–visible upconversion using conductive films of PbS QDs capped with short iodide ligands, inspired by materials used in optically thick QD solar cells. Bilayer devices with conductive PbS QDs demonstrate upconversion (λ: 808 nm → 612 nm), and the best carrier-based devices exhibit 30 ± 10% improved brightness in the linear regime relative to the best devices sensitized by the same PbS QDs with their native, oleic acid ligands. We show that conductive devices can retain 35 ± 7% of their best absolute upconversion brightness in devices thick enough to absorb 9.6 ± 0.1% of the incident NIR light (a >30× improvement over comparable devices with insulating ligands). However, we observe a performance roll-off beyond 1.5 monolayers that implies unaddressed internal-efficiency challenges. Using steady-state and transient optical spectroscopies, we attribute this roll-off to two unwanted processes caused by both types of QD films used here: (1) FRET-dependent back-transfer of excitations (from the organic to the PbS QDs); and (2) QD-film-induced changes in the morphology of the organic layer that impair rubrene-to-DBP energy transfer. These results highlight future enhancements to the architecture that could mitigate these losses and unlock the long-range sensitization capabilities of conductive PbS QD films.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Department of Chemistry, University of Toronto, Toronto, OntarioM5S 3H6, Canada.
ORCID-Profile: Samihat Rahman, Miguel Albaladejo-Siguan, Guillermo Lozano-Onrubia, Kelly-Marie Y Yokuda, Sidrah Rana, Gilbert C Walker, Mark W B Wilson
Förderung
- Canada Foundation for Innovation
- Ontario Ministry of Research, Innovation and Science
- University of Toronto
- Natural Sciences and Engineering Research Council of Canada (NSERC)
Zitieren
APA
Rahman, S., Albaladejo-Siguan, M., Lozano-Onrubia, G., Yokuda, K. Y., Rana, S., Walker, G. C., & Wilson, M. W. B. (2026). Near-Infrared–to–Visible Upconversion Sensitized by Conductive Films of PbS Quantum Dots. ACS Nano, 20(29), 20688-20702. https://doi.org/10.1021/acsnano.6c05335
Vancouver
Rahman S, Albaladejo-Siguan M, Lozano-Onrubia G, Yokuda KY, Rana S, Walker GC, et al. Near-Infrared–to–Visible Upconversion Sensitized by Conductive Films of PbS Quantum Dots. ACS Nano. 2026;20(29):20688-20702. doi:10.1021/acsnano.6c05335
BibTeX
@article{Rahman2026,
author = {Rahman, Samihat and Albaladejo-Siguan, Miguel and Lozano-Onrubia, Guillermo and Yokuda, Kelly-Marie Y and Rana, Sidrah and Walker, Gilbert C and Wilson, Mark W B},
title = {Near-Infrared–to–Visible Upconversion Sensitized by Conductive Films of PbS Quantum Dots},
journal = {ACS Nano},
year = {2026},
volume = {20},
number = {29},
pages = {20688--20702},
doi = {10.1021/acsnano.6c05335}
}
EUVIMED