EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

A Low-Cost, Open-Source, In Situ, Near-Real-Time Sensor for the Detection of Nitrate and Ammonia in Environmental Waters

Mehran Janmohammadi, Baiqian Shi, David McCarthy iD

ACS ES&T Water · 10.07.2026 · 6 (7) · 4485-4496

DOI: 10.1021/acsestwater.6c00349 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS ES&T Water, online erschienen am 29.06.2026. Verfasst von Mehran Janmohammadi und 2 weiteren Autor:innen. Beteiligte Einrichtung: BoSL Water Monitoring and Control, Department of Civil Engineering, Monash University, Wellington Road, Clayton 3800, Australia. Die Arbeit nennt 42 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: South East Water, Natural Sciences and Engineering Research Council of Canada.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Elevated levels of ammonia and nitrate in water bodies contribute to environmental issues such as eutrophication and pose serious risks to human health and aquatic life. Traditional monitoring methods rely on grab sampling, and existing in situ sensor technologies are often prohibitively expensive, which limits their widespread deployment. This study presents a low-cost, in situ, near-real-time sensor and a hand-held device for the detection and monitoring of ammonia and nitrate in water. The hand-held device demonstrated excellent performance during laboratory testing, achieving an R 2 of 0.96 when estimating both ammonia and nitrate concentrations in real environmental samples. It reliably quantified both nutrients across a broad range, with accurate measurements observed up to 10 mg/L. The in situ system showed reliable performance for ammonia in environmental samples ( R 2 = 0.76) and detected ammonia down to 0.1 mg/L. However, below this threshold, signal variability increased, and measurements became less consistent. During four field sampling periods, it demonstrated reliable performance in measuring ammonia concentrations, achieving an R 2 of 0.86 and a Nash–Sutcliffe efficiency (NSE) of 0.83. The results showed that the low-cost sensor can operate for 2 weeks by sampling every 40 min using just one kit of low-cost reagents (16 USD per kit, and 0.09 USD per sample).

Schlagwörter

Stichwörter der Autor:innen

3D rapid prototypingammoniacolorimetricnitratesensorwater quality

Autor:innen und Institutionen

  • BoSL Water Monitoring and Control, Department of Civil Engineering, Monash University, Wellington Road, Clayton 3800, Australia.
  • School of Civil & Environmental Engineering, Queensland University of Technology, Brisbane, QLD 4001, Australia.
  • Canada Excellence Research Chair (CERC) in Waterborne Pathogens, School of Environmental Sciences, University of Guelph, 50 Stone Road East, Guelph N1G 2W1, Canada.

ORCID-Profile: David McCarthy

Förderung

  • South East Water
  • Natural Sciences and Engineering Research Council of Canada

Zitieren

APA

Janmohammadi, M., Shi, B., & McCarthy, D. (2026). A Low-Cost, Open-Source, In Situ, Near-Real-Time Sensor for the Detection of Nitrate and Ammonia in Environmental Waters. ACS ES&T Water, 6(7), 4485-4496. https://doi.org/10.1021/acsestwater.6c00349

Vancouver

Janmohammadi M, Shi B, McCarthy D. A Low-Cost, Open-Source, In Situ, Near-Real-Time Sensor for the Detection of Nitrate and Ammonia in Environmental Waters. ACS ES&T Water. 2026;6(7):4485-4496. doi:10.1021/acsestwater.6c00349

BibTeX
@article{Janmohammadi2026,
  author = {Janmohammadi, Mehran and Shi, Baiqian and McCarthy, David},
  title = {A Low-Cost, Open-Source, In Situ, Near-Real-Time Sensor for the Detection of Nitrate and Ammonia in Environmental Waters},
  journal = {ACS ES&T Water},
  year = {2026},
  volume = {6},
  number = {7},
  pages = {4485--4496},
  doi = {10.1021/acsestwater.6c00349}
}
Kostenlos starten →