Rapid Synthesis of Fibrous Phosphorus for Ammonia Sensing at Room Temperature
ACS Applied Nano Materials · 03.11.2026
DOI: 10.1021/acsanm.6c05096 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Applied Nano Materials, online erschienen am 03.11.2026. Verfasst von Guangfu Luo und 5 weiteren Autor:innen. Die Arbeit nennt 47 Literaturangaben. Gefördert von: National Natural Science Foundation of China, Natural Science Foundation of Guangdong Province.
Abstract (Originalsprache)
Ammonia (NH3) is a representative reducing toxic gas whose rapid, low-concentration detection is important in constant-temperature, constant-humidity environments such as semiconductor cleanrooms, yet existing NH3 sensors often suffer from high operating temperatures or slow response/recovery kinetics. Fibrous phosphorus (FP), a layered allotrope of elemental phosphorus with a parallel tubular structure, is an appealing sensing candidate, but its efficient preparation and gas-sensing potential remain underexplored. Here, we report an iodine-assisted chemical vapor transport method that enables gram-scale synthesis of FP within 5 h with a yield exceeding 99%, without the need for precise temperature-gradient control. The key is the iodine-mediated cleavage of P4 cages and the directed assembly of active phosphorus fragments into tubular FP. Taking advantage of the weak interlayer van der Waals interactions, high-quality FP nanoribbons (FP-NRs) with an average width of ∼50 nm, an average length of ∼6 μm, and aspect ratios exceeding 150 for ∼60% of the ribbons are obtained by 60 min of ice-bath exfoliation. The FP-NRs sensor exhibits a high response of 826% toward 100 ppm NH3 at room temperature, with response/recovery times of 31/7 s under the 90% criterion, and remains responsive at 2 ppm NH3 (response 69.8%). When all tested gases are compared at the same concentration, the response to NH3 is significantly higher than that to the interfering gases. Combined DFT calculations and in situ FTIR/Raman measurements reveal that NH3 adsorption on FP is dominated by physical adsorption (adsorption energy −0.26 eV; Bader charge transfer ∼0.02 e), which accounts for the high sensitivity, selectivity, and fast recovery. This work provides a scalable route to FP nanoribbons and demonstrates their potential for practical room-temperature NH3 sensing.
Förderung
- National Natural Science Foundation of China
- Natural Science Foundation of Guangdong Province
Zitieren
APA
Luo, G., Chen, J., Ye, C., Wang, P., Zhang, X., & Zhang, S. (2026). Rapid Synthesis of Fibrous Phosphorus for Ammonia Sensing at Room Temperature. ACS Applied Nano Materials. https://doi.org/10.1021/acsanm.6c05096
Vancouver
Luo G, Chen J, Ye C, Wang P, Zhang X, Zhang S. Rapid Synthesis of Fibrous Phosphorus for Ammonia Sensing at Room Temperature. ACS Applied Nano Materials. 2026. doi:10.1021/acsanm.6c05096
BibTeX
@article{Luo2026,
author = {Luo, Guangfu and Chen, Junpeng and Ye, Cong and Wang, Pengtao and Zhang, Xishuo and Zhang, Shuai},
title = {Rapid Synthesis of Fibrous Phosphorus for Ammonia Sensing at Room Temperature},
journal = {ACS Applied Nano Materials},
year = {2026},
doi = {10.1021/acsanm.6c05096}
}
EUVIMED