EUVIMEDEUVIMED entdecken
Crossref

Effect of Filler Conductive Threshold on Cathodic Protection and Anticorrosion Mechanism of Zinc-rich Epoxy Coatings

Yu Wang, Yukang Sun, Xiaolong Zhao, Junfeng Li, Huachao Ma, Kuilin Lv iD

ACS Applied Materials & Interfaces · 28.10.2026 · 18 (42) · 58252-58268

DOI: 10.1021/acsami.6c11689 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Materials & Interfaces, online erschienen am 19.10.2026. Verfasst von Yu Wang und 5 weiteren Autor:innen. Beteiligte Einrichtung: China Testing & Certification International Group Co. Ltd. , Chaoyang District, Beijing10024, China. Die Arbeit nennt 39 Literaturangaben. Gefördert von: Beijing Nova Program, National Outstanding Youth Science Fund Project of National Natural Science Foundation of China.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

In this study, reduced graphene oxide (rGO) fillers with electrical conductivities spanning nearly five orders of magnitude (4.2 × 10–4 – 20.58 S/cm) were prepared by hydrothermal reduction and incorporated at a fixed loading of 0.5 wt % into zinc-rich epoxy coatings containing 50 wt % zinc powder. The influence of the reduction-dependent rGO state on coating structure, interfacial properties, cathodic protection, and corrosion resistance was systematically evaluated. A non-monotonic conductivity–performance relationship was observed, with rGO160 (1.62 S/cm) showing the best overall protection under the present formulation. XPS and FTIR revealed that rGO160 retained an intermediate surface polarity, while cross-sectional SEM and mechanical tests indicated a dense coating structure, reduced interfacial defects, and the highest pull-off adhesion strength (∼6.4 MPa). KPFM further showed a comparatively uniform contact-potential-difference distribution. After 30 days of immersion, the MZrZE-rGO160 coating retained the highest low-frequency impedance modulus (|Z|0.01Hz ≈ 4 × 107 Ω·cm2) and exhibited the lowest relative corrosion propagation after 300 h of salt-spray exposure. DFT calculations showed comparatively less favorable H2O and O2 adsorption on the idealized rGO160 surface (+0.03 and +0.61 eV, respectively), serving as supplementary thermodynamic descriptors rather than direct kinetic evidence. The results demonstrate that the optimum protection arises from the coupled balance of conductivity, surface chemistry, sheet dispersion/restacking, conductive-network connectivity, and coating integrity. Accordingly, 1.62 S cm–1 should be regarded as a formulation-dependent optimum among the investigated rGO fillers rather than a universal conductivity threshold.

Schlagwörter

Stichwörter der Autor:innen

cathodic protectionconductivity–performance relationshipcorrosion resistancereduced graphene oxidesurface chemistryzinc-rich epoxy coating

Autor:innen und Institutionen

  • China Testing & Certification International Group Co. Ltd. , Chaoyang District, Beijing10024, China.
  • China State Key Laboratory of Green Building Materials, China State Building Materials, Research Institute Co. Ltd. , Chaoyang District, Beijing10024, China.

ORCID-Profile: Kuilin Lv

Förderung

  • Beijing Nova Program
  • National Outstanding Youth Science Fund Project of National Natural Science Foundation of China

Zitieren

APA

Wang, Y., Sun, Y., Zhao, X., Li, J., Ma, H., & Lv, K. (2026). Effect of Filler Conductive Threshold on Cathodic Protection and Anticorrosion Mechanism of Zinc-rich Epoxy Coatings. ACS Applied Materials & Interfaces, 18(42), 58252-58268. https://doi.org/10.1021/acsami.6c11689

Vancouver

Wang Y, Sun Y, Zhao X, Li J, Ma H, Lv K. Effect of Filler Conductive Threshold on Cathodic Protection and Anticorrosion Mechanism of Zinc-rich Epoxy Coatings. ACS Applied Materials & Interfaces. 2026;18(42):58252-58268. doi:10.1021/acsami.6c11689

BibTeX
@article{Wang2026,
  author = {Wang, Yu and Sun, Yukang and Zhao, Xiaolong and Li, Junfeng and Ma, Huachao and Lv, Kuilin},
  title = {Effect of Filler Conductive Threshold on Cathodic Protection and Anticorrosion Mechanism of Zinc-rich Epoxy Coatings},
  journal = {ACS Applied Materials & Interfaces},
  year = {2026},
  volume = {18},
  number = {42},
  pages = {58252--58268},
  doi = {10.1021/acsami.6c11689}
}
Kostenlos starten →