EUVIMEDEUVIMED entdecken
Crossref

Gas Pump-Induced Crystallization of MAPbBr 3 Perovskite Assisted by Ligands for Sensitive Detection Applications

Lili Gao iD, Pei Fang, Ye Yang, Ping Hu, Siyan Yang, Jiale Zhu, Fan Yang iD, Hua Wang, Kui Zhao iD

ACS Applied Materials & Interfaces · 26.11.2025 · 17 (47) · 65290-65299

DOI: 10.1021/acsami.5c16636 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Materials & Interfaces, online erschienen am 14.11.2025. Verfasst von Lili Gao und 8 weiteren Autor:innen. Beteiligte Einrichtung: School of Metallurgy Engineering, Xi'an International Science and Technology Cooperation Base for Manufacturing of Special Powder and Powder Metallur…. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 44 Literaturangaben. Gefördert von: Shaanxi Science and Technology Association, State Key Laboratory for Mechanical Behavior of Materials, Natural Science Foundation of Shaanxi Province.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Because of their excellent stability and photoelectric properties, perovskite single crystals have been widely applied in fields such as detection and photovoltaics. This study demonstrated a ligand-assisted gas pump method for perovskite crystallization, in which the influence of the pressure change rate on the morphology of perovskite crystals and the quality of ligand-assisted crystallization were investigated. CH3NH3PbBr3 single crystals were obtained via the gas pump method assisted with 3-(decyldimethylazaniumyl)propanesulfonate (DPSI) as the ligand for crystallization. With varying rates of environmental pressure variation, the (100) crystal surface exhibited a step-like growth process, and the steps were "center-initiated, outward-expanding". When the pressure changes rapidly, the steps are wide and steep; as the pressure change rate gradually slows, the slope of the steps becomes gentler. When the growth rate reached 20 Pa/h, the crystal surface became flat, and the growth steps disappeared. The rate of pressure change enables control of the crystal step morphology. To further control crystal growth and quality, the DPSI ligand was employed during the crystal growth process under low-pressure conditions. The -SO3- group in DPSI anchors uncoordinated Pb2+, effectively suppressing solution nucleation. This interaction significantly enhances crystal quality, increases crystal stability, and effectively expands the size of MAPbBr3 crystals. The optimized MAPbBr3 detector achieved an outstanding X-ray sensitivity of up to 10798 μC Gyair-1 cm-2 at a bias of 50 V, along with a minimum detectable dose rate of 0.19 μGyair s-1 for 40 kVp X-rays. These advancements have contributed to reducing radiation exposure for patients during medical X-ray diagnostics. The methodology employed in this study enables the fabrication of high-quality crystals through controlled growth rate modulation, demonstrating significant potential for detector applications.

Schlagwörter

Stichwörter der Autor:innen

Gas pumpLigand-assistedPerovskite single crystalStep-like growthX-ray detection

Autor:innen und Institutionen

  • School of Metallurgy Engineering, Xi'an International Science and Technology Cooperation Base for Manufacturing of Special Powder and Powder Metallurgy, Xi'an University of Architecture and Technology, Xi'an 710055, Chi…
  • School of Materials Science and Engineering, Shaanxi Normal University, Xi'an 710119, China.
  • School of Environmental and Municipal Engineering, Xi'an University of Architecture and Technology, Xi'an 710075, China.
  • Xi'an Head Accurate Materials Testing Co., Ltd., Xi'an 710599, China.

ORCID-Profile: Lili Gao, Fan Yang, Kui Zhao

Förderung

  • Shaanxi Science and Technology Association
  • State Key Laboratory for Mechanical Behavior of Materials
  • Natural Science Foundation of Shaanxi Province
  • Key Research and Development Projects of Shaanxi Province
  • Scientific Research Program of Youth Innovation Team of Shaanxi

Zitieren

APA

Gao, L., Fang, P., Yang, Y., Hu, P., Yang, S., Zhu, J., Yang, F., Wang, H., & Zhao, K. (2025). Gas Pump-Induced Crystallization of MAPbBr 3 Perovskite Assisted by Ligands for Sensitive Detection Applications. ACS Applied Materials & Interfaces, 17(47), 65290-65299. https://doi.org/10.1021/acsami.5c16636

Vancouver

Gao L, Fang P, Yang Y, Hu P, Yang S, Zhu J, et al. Gas Pump-Induced Crystallization of MAPbBr 3 Perovskite Assisted by Ligands for Sensitive Detection Applications. ACS Applied Materials & Interfaces. 2025;17(47):65290-65299. doi:10.1021/acsami.5c16636

BibTeX
@article{Gao2025,
  author = {Gao, Lili and Fang, Pei and Yang, Ye and Hu, Ping and Yang, Siyan and Zhu, Jiale and Yang, Fan and Wang, Hua and Zhao, Kui},
  title = {Gas Pump-Induced Crystallization of MAPbBr 3 Perovskite Assisted by Ligands for Sensitive Detection Applications},
  journal = {ACS Applied Materials & Interfaces},
  year = {2025},
  volume = {17},
  number = {47},
  pages = {65290--65299},
  doi = {10.1021/acsami.5c16636}
}
Kostenlos starten →