Surface-Modified Rod-Like Cd x Zn 1– x S QDs-Sensitized Photoanode in Solar PEC Cell for Enhancing Yield and Stability of Hydrogen Evolution
ACS Applied Materials & Interfaces · 03.12.2025 · 17 (48) · 65519-65528
DOI: 10.1021/acsami.5c07946 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Applied Materials & Interfaces, online erschienen am 20.11.2025. Verfasst von Chuang Chen und 4 weiteren Autor:innen. Beteiligte Einrichtung: School of Material Science and Chemical Engineering, Harbin University of Science and Technology, Harbin 150040, China. Die Arbeit wurde bisher 2-mal zitiert (Crossref) und nennt 51 Literaturangaben. Gefördert von: Natural Science Foundation of Heilongjiang Province, National Natural Science Foundation of China, Natural Science Foundation of Shandong Province.
Abstract (Originalsprache)
The rod-like CdxZn1-xS quantum dots (CZS QDs) with a low length-diameter ratio (13:3.5 nm) and high uniformity in shape and size were successfully synthesized by a hot-injection process for hydrogen evolution in solar photoelectrochemical (PEC) cells. Compared with traditional sphere-like QDs with an average diameter of ∼4.5 nm, these rod-like CZS QDs with a low length-diameter ratio sensitized TiO2/FTO (F-doped SnO2) glass photoanode show higher absorptance in the visible region and photocurrent density. However, the electron-hole recombination does not increase apparently due to their similar PL spectra. ZnS QDs were deposited on a CZS QDs-sensitized TiO2/FTO photoanode via an in situ SILAR process to improve photoelectrical properties by inhibiting reversed current and increasing bulk charge separation efficiency and hydrophilicity of the photoanodes. However, excess ZnS QDs will impair the photoelectrical performance due to the decrease of surface injection efficiency caused by too many introduced surface defects. The bias voltage plays the primary role of overpassing the potential barrier as well as providing weak electric catalysis in PEC hydrogen evolution. The decrease of the length-diameter ratio of rod-like CZS QDs has not only enhanced PEC efficiency but also ensured considerable stability of the cells in H2 evolution. The PEC cell consisting of 8ZnS/CZS/TiO2 and a Pt counter electrode realizes ∼46% improvement in hydrogen evolution yield and rate compared with the CZS/TiO2 photoanode-based cell under one sun (AM 1.5 G, 100 mW/cm2) at 0.8 V bias, and especially exhibits significantly high stability, with 87.4% hydrogen production efficiency retained after a total 20 h PEC hydrogen evolution process.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- School of Material Science and Chemical Engineering, Harbin University of Science and Technology, Harbin 150040, China.
ORCID-Profile: Wei Zheng
Förderung
- Natural Science Foundation of Heilongjiang Province
- National Natural Science Foundation of China
- Natural Science Foundation of Shandong Province
Zitieren
APA
Chen, C., Chen, A., Shao, S., Lian, Y., & Zheng, W. (2025). Surface-Modified Rod-Like Cd x Zn 1– x S QDs-Sensitized Photoanode in Solar PEC Cell for Enhancing Yield and Stability of Hydrogen Evolution. ACS Applied Materials & Interfaces, 17(48), 65519-65528. https://doi.org/10.1021/acsami.5c07946
Vancouver
Chen C, Chen A, Shao S, Lian Y, Zheng W. Surface-Modified Rod-Like Cd x Zn 1– x S QDs-Sensitized Photoanode in Solar PEC Cell for Enhancing Yield and Stability of Hydrogen Evolution. ACS Applied Materials & Interfaces. 2025;17(48):65519-65528. doi:10.1021/acsami.5c07946
BibTeX
@article{Chen2025,
author = {Chen, Chuang and Chen, Ao and Shao, Shuai and Lian, Yang and Zheng, Wei},
title = {Surface-Modified Rod-Like Cd x Zn 1– x S QDs-Sensitized Photoanode in Solar PEC Cell for Enhancing Yield and Stability of Hydrogen Evolution},
journal = {ACS Applied Materials & Interfaces},
year = {2025},
volume = {17},
number = {48},
pages = {65519--65528},
doi = {10.1021/acsami.5c07946}
}
EUVIMED