Antifouling Ultrafiltration Membranes with Enhanced Stability and Hydrophilicity by Self-assembly and Cross-linking of Block Copolymer Additives
ACS Applied Materials & Interfaces · 11.06.2025 · 17 (23) · 34470-34482
DOI: 10.1021/acsami.5c02731 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Applied Materials & Interfaces, online erschienen am 29.05.2025. Verfasst von Shaobin Wen und 5 weiteren Autor:innen. Beteiligte Einrichtung: Key Laboratory of New Membrane Materials, Ministry of Industry and Information Technology, School of Environmental and Biological Engineering, Nanjin…. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 59 Literaturangaben. Gefördert von: Fundamental Research Funds for the Central Universities.
Abstract (Originalsprache)
Membranes prepared by classical nonsolvent-induced phase separation (NIPS) are often criticized for disadvantages such as a thick, dense skin layer; low porosity; and a wide pore size distribution. The use of polymeric additives can enhance the membrane's hydrophilicity, permeability, and antifouling performance. However, the leaching of traditional hydrophilic polymeric additives could limit the long-term operation performance of the membranes. Herein, amphiphilic block copolymer Poly(PEG-b-EAMO) with pendant photopolymerizable functional groups was prepared by controlled radical polymerization and used as additives for membrane fabrication. PVDF membranes were prepared through either simple blending modification or blending combined with in situ cross-linking by cationic photopolymerization, respectively. The hydrophilicity of the modified membranes was enhanced, and the adsorption capacities of bovine serum albumin (BSA) and humic acid (HA) were significantly reduced. The water contact angle of M0 was 86.1°. At the same time, M5 had the lowest contact angle of 63.3°. M5 also exhibited the lowest adsorption (16.2 and 5.4 μg/cm2 for BSA and HA, respectively), which were significantly lower than those of M0 (45.1 and 22.0 μg/cm2, respectively). The optimum membrane M5 with superior hydrophilic and antifouling properties had the highest retention for BSA and HA, as well as flux recovery rates (FRR). During the first water-BSA-water cycle test, M5 exhibited the highest FRR (80.6%), while M0 had a much lower FRR of only 46.5%. A similar trend was observed in the water-HA-water cycle test, where M5 achieved the highest FRR (91.0%) in the first cycle. In addition, M5 also showed excellent stability and still maintained excellent hydrophilicity and permeability after 48 h of ethanol immersion.
Schlagwörter
Stichwörter der Autor:innen
Autor:innen und Institutionen
- Key Laboratory of New Membrane Materials, Ministry of Industry and Information Technology, School of Environmental and Biological Engineering, Nanjing University of Science and Technology, Nanjing 210094, PR China.
- Institute of Polymer Ecomaterials, School of Environmental and Biological Engineering, Nanjing University of Science and Technology, Nanjing 210094, PR China.
ORCID-Profile: Qiang Zhang
Förderung
- Fundamental Research Funds for the Central Universities
Zitieren
APA
Wen, S., Fan, L., Wang, T., Zhang, J., Peng, B., & Zhang, Q. (2025). Antifouling Ultrafiltration Membranes with Enhanced Stability and Hydrophilicity by Self-assembly and Cross-linking of Block Copolymer Additives. ACS Applied Materials & Interfaces, 17(23), 34470-34482. https://doi.org/10.1021/acsami.5c02731
Vancouver
Wen S, Fan L, Wang T, Zhang J, Peng B, Zhang Q. Antifouling Ultrafiltration Membranes with Enhanced Stability and Hydrophilicity by Self-assembly and Cross-linking of Block Copolymer Additives. ACS Applied Materials & Interfaces. 2025;17(23):34470-34482. doi:10.1021/acsami.5c02731
BibTeX
@article{Wen2025,
author = {Wen, Shaobin and Fan, Liyuan and Wang, Tianheng and Zhang, Jingyu and Peng, Bin and Zhang, Qiang},
title = {Antifouling Ultrafiltration Membranes with Enhanced Stability and Hydrophilicity by Self-assembly and Cross-linking of Block Copolymer Additives},
journal = {ACS Applied Materials & Interfaces},
year = {2025},
volume = {17},
number = {23},
pages = {34470--34482},
doi = {10.1021/acsami.5c02731}
}
EUVIMED