EUVIMEDEUVIMED entdecken
Open Access · CC BY-NC-ND 4.0

Photovoltaic Efficiency Enhancement of Indium-Free Wide-Bandgap Chalcopyrite Solar Cells via an Aluminum-Induced Back-Surface Field Effect

Shogo Ishizuka iD, Jiro Nishinaga iD, Yukiko Kamikawa iD, Takeshi Nishida, Paul J Fons

ACS Applied Materials & Interfaces · 15.01.2025 · 17 (2) · 3136-3145

DOI: 10.1021/acsami.4c12891 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Materials & Interfaces, online erschienen am 13.11.2024. Verfasst von Shogo Ishizuka und 4 weiteren Autor:innen. Beteiligte Einrichtung: Global Zero Emission Research Center, National Institute of Advanced Industrial Science and Technology 1-1-1 Umezono, Tsukuba, Ibaraki 305-8568, Japa…. Die Arbeit wurde bisher 12-mal zitiert (Crossref) und nennt 53 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY-NC-ND 4.0). Gefördert von: New Energy and Industrial Technology Development Organization, Japan Society for the Promotion of Science.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Wide-bandgap chalcopyrite materials are attractive candidates for a wide variety of energy conversion devices such as the top cell of tandem-type photovoltaic devices and photoelectrochemical water splitting hydrogen evolution devices. Nevertheless, simultaneous realization of high open circuit voltage (VOC) and high fill factor (FF) values has been challenging, and thus, the photovoltaic performance has been limited. In this article, high VOC and high FF values of wide-gap chalcopyrite CuGaSe2 thin-film solar cells are simultaneously demonstrated using an aluminum-induced back-surface field effect. An independently certified photovoltaic efficiency of 12.25% was obtained from an elemental In-free CuGaSe2:Al (bandgap energy ∼1.7 eV) solar cell (VOC: 0.959 V, short circuit current density: 17.64 mA cm-2, FF: 72.5%). In addition, an over 1 V-VOC CuGaSe2 cell (FF: 74.5%) was obtained even with the use of a conventional CdS buffer layer. Although incorporation of aluminum often leads to degradation of the chalcopyrite solar cell performance, the addition of a small amount of aluminum is found to be effective in enhancing wide-gap chalcopyrite photovoltaic performance.

Schlagwörter

Stichwörter der Autor:innen

CIGSCuGaSe2back surface fieldchalcopyritewide-gap thin-film solar cell

Autor:innen und Institutionen

  • Global Zero Emission Research Center, National Institute of Advanced Industrial Science and Technology 1-1-1 Umezono, Tsukuba, Ibaraki 305-8568, Japan.
  • Department of Electronics and Electrical Engineering, Keio University, 4-1-1 Hiyoshi, Kohoku-ku, Yokohama, Kanagawa 223-8521, Japan.

ORCID-Profile: Shogo Ishizuka, Jiro Nishinaga, Yukiko Kamikawa

Förderung

  • New Energy and Industrial Technology Development Organization
  • Japan Society for the Promotion of Science

Zitieren

APA

Ishizuka, S., Nishinaga, J., Kamikawa, Y., Nishida, T., & Fons, P. J. (2025). Photovoltaic Efficiency Enhancement of Indium-Free Wide-Bandgap Chalcopyrite Solar Cells via an Aluminum-Induced Back-Surface Field Effect. ACS Applied Materials & Interfaces, 17(2), 3136-3145. https://doi.org/10.1021/acsami.4c12891

Vancouver

Ishizuka S, Nishinaga J, Kamikawa Y, Nishida T, Fons PJ. Photovoltaic Efficiency Enhancement of Indium-Free Wide-Bandgap Chalcopyrite Solar Cells via an Aluminum-Induced Back-Surface Field Effect. ACS Applied Materials & Interfaces. 2025;17(2):3136-3145. doi:10.1021/acsami.4c12891

BibTeX
@article{Ishizuka2025,
  author = {Ishizuka, Shogo and Nishinaga, Jiro and Kamikawa, Yukiko and Nishida, Takeshi and Fons, Paul J},
  title = {Photovoltaic Efficiency Enhancement of Indium-Free Wide-Bandgap Chalcopyrite Solar Cells via an Aluminum-Induced Back-Surface Field Effect},
  journal = {ACS Applied Materials & Interfaces},
  year = {2025},
  volume = {17},
  number = {2},
  pages = {3136--3145},
  doi = {10.1021/acsami.4c12891}
}
Kostenlos starten →