EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Overcoming Microstructural Defects at the Buried Interface of Formamidinium-Based Perovskite Solar Cells

Heng-Yi Lin, Zhongyao Jiang, Shi-Chun Liu, Zhaoyi Du, Shih-En Hsu, Yun-Shan Li, Wei-Jia Qiu, Hongta Yang iD, Thomas J Macdonald iD, Martyn A McLachlan iD, Chieh-Ting Lin iD

ACS Applied Materials & Interfaces · 11.09.2024 · 16 (36) · 47763-47772

DOI: 10.1021/acsami.4c11052 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Materials & Interfaces, online erschienen am 27.08.2024. Verfasst von Heng-Yi Lin und 10 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemical Engineering, National Chung Hsing University, 145 Xingda Road, Taichung 40227, Taiwan. Die Arbeit wurde bisher 23-mal zitiert (Crossref) und nennt 41 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Royal Society, Royal Commission for the Exhibition of 1851, National Science and Technology Council.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Since the advent of formamidinium (FA)-based perovskite photovoltaics (PVs), significant performance enhancements have been achieved. However, a critical challenge persists: the propensity for void formation in the perovskite film at the buried perovskite-interlayer interface has a deleterious effect on device performance. With most emerging perovskite PVs adopting the p-i-n architecture, the specific challenge lies at the perovskite-hole transport layer (HTL) interface, with previous strategies to overcome this limitation being limited to specific perovskite-HTL combinations; thus, the lack of universal approaches represents a bottleneck. Here, we present a novel strategy that overcomes the formation of such voids (microstructural defects) through a film treatment with methylammonium chloride (MACl). Specifically, our work introduces MACl via a sequential deposition method, having a profound impact on the microstructural defect density at the critical buried interface. Our technique is independent of both the HTL and the perovskite film thickness, highlighting the universal nature of this approach. By employing device photoluminescence measurements and conductive atomic force microscopy, we reveal that when present, such voids impede charge extraction, thereby diminishing device short-circuit current. Through comprehensive steady-state and transient photoluminescence spectroscopy analysis, we demonstrate that by implementing our MACl treatment to remedy these voids, devices with reduced defect states, suppressed nonradiative recombination, and extended carrier lifetimes of up to 2.3 μs can be prepared. Furthermore, our novel treatment reduces the stringent constraints around antisolvent choice and dripping time, significantly extending the processing window for the perovskite absorber layer and offering significantly greater flexibility for device fabrication.

Schlagwörter

Stichwörter der Autor:innen

buried interfacecharge extractiondevice photoluminescencemethylammonium chloridemicrostructural defectsperovskite solar cellswide processing window

Autor:innen und Institutionen

  • Department of Chemical Engineering, National Chung Hsing University, 145 Xingda Road, Taichung 40227, Taiwan.
  • Department of Materials, Molecular Sciences Research Hub, Imperial College London, 82 Wood Ln, London W12 0BZ, U.K.
  • Department of Electronic & Electrical Engineering, University College London, Torrington Place, London WC1E 7JE, U.K.
  • Innovation and Development Center of Sustainable Agriculture, National Chung Hsing University, 145 Xingda Road, Taichung 40227, Taiwan.

ORCID-Profile: Hongta Yang, Thomas J Macdonald, Martyn A McLachlan, Chieh-Ting Lin

Förderung

  • Royal Society
  • Royal Commission for the Exhibition of 1851
  • National Science and Technology Council
  • Ministry of Education, Taiwan

Zitieren

APA

Lin, H. Y., Jiang, Z., Liu, S. C., Du, Z., Hsu, S. E., Li, Y. S., Qiu, W. J., Yang, H., Macdonald, T. J., McLachlan, M. A., & Lin, C. T. (2024). Overcoming Microstructural Defects at the Buried Interface of Formamidinium-Based Perovskite Solar Cells. ACS Applied Materials & Interfaces, 16(36), 47763-47772. https://doi.org/10.1021/acsami.4c11052

Vancouver

Lin HY, Jiang Z, Liu SC, Du Z, Hsu SE, Li YS, et al. Overcoming Microstructural Defects at the Buried Interface of Formamidinium-Based Perovskite Solar Cells. ACS Applied Materials & Interfaces. 2024;16(36):47763-47772. doi:10.1021/acsami.4c11052

BibTeX
@article{Lin2024,
  author = {Lin, Heng-Yi and Jiang, Zhongyao and Liu, Shi-Chun and Du, Zhaoyi and Hsu, Shih-En and Li, Yun-Shan and Qiu, Wei-Jia and Yang, Hongta and Macdonald, Thomas J and McLachlan, Martyn A and Lin, Chieh-Ting},
  title = {Overcoming Microstructural Defects at the Buried Interface of Formamidinium-Based Perovskite Solar Cells},
  journal = {ACS Applied Materials & Interfaces},
  year = {2024},
  volume = {16},
  number = {36},
  pages = {47763--47772},
  doi = {10.1021/acsami.4c11052}
}
Kostenlos starten →