EUVIMEDEUVIMED entdecken
Crossref

Effect of Bias Frequency on Bottom-Up SiO 2 Gap-Filling Using Plasma-Enhanced Atomic Layer Deposition

Ye Ji Shin iD, Ho Gon Kim, Seung Yup Choi, Seo Min Kim, Ji Eun Kang, Hye Won Han, Ji Min Kim, Geun Hwi Kim, Geun Young Yeom iD

ACS Applied Materials & Interfaces · 07.08.2024 · 16 (31) · 41642-41652

DOI: 10.1021/acsami.4c06106 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Materials & Interfaces, online erschienen am 29.07.2024. Verfasst von Ye Ji Shin und 8 weiteren Autor:innen. Beteiligte Einrichtung: Department of Advanced Materials and Science Engineering, Sungkyunkwan University (SKKU), Suwon-si, Gyeonggi-do 16419, Republic of Korea. Die Arbeit wurde bisher 4-mal zitiert (Crossref) und nennt 22 Literaturangaben. Gefördert von: Ministry of Trade, Industry and Energy, Korea Evaluation Institute of Industrial Technology.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

High-aspect-ratio patterns are required for next-generation three-dimensional (3D) semiconductor devices. However, it is challenging to eliminate voids and seams during gap-filling of these high-aspect-ratio patterns, such as deep trenches, especially for nanoscale high-aspect-ratio patterns. In this study, a SiO2 plasma-enhanced atomic layer deposition process incorporated with ion collision using bias power to the substrate was used for bottom-up trench gap-filling. The effect of bias power frequency on SiO2 trench gap-filling was then investigated. Results showed that changes in bias power frequency did not significantly change the process rate, such as SiO2 growth per cycle. At relatively low bias power frequencies, high-energy ions formed an overhang at the entrance of the high-aspect-ratio trench pattern through sputter etching and redeposition, blocking the pattern entrance. However, at relatively high-frequency bias power, overhang formation due to sputtering did not occur. In the trench interior, due to a scattering effect of ions, deposition was thicker at the bottom of the trench than that at the top, achieving bottom-up gap-filling and void-free gap-filling.

Schlagwörter

Stichwörter der Autor:innen

PEALDbias frequencybottom-upgap-fillingvoid-free

Autor:innen und Institutionen

  • Department of Advanced Materials and Science Engineering, Sungkyunkwan University (SKKU), Suwon-si, Gyeonggi-do 16419, Republic of Korea.
  • School of Chemical Engineering, Sungkyunkwan University (SKKU), Suwon-si, Gyeonggi-do 16419, Republic of Korea.
  • Department of Semiconductor Convergence Engineering, Sungkyunkwan University (SKKU), Suwon-si, Gyeonggi-do 16419, Republic of Korea.
  • SKKU Advanced Institute of Nano Technology (SAINT), Sungkyunkwan University, Suwon-si, Gyeonggi-do 16419, Republic of Korea.

ORCID-Profile: Ye Ji Shin, Geun Young Yeom

Förderung

  • Ministry of Trade, Industry and Energy
  • Korea Evaluation Institute of Industrial Technology

Zitieren

APA

Shin, Y. J., Kim, H. G., Choi, S. Y., Kim, S. M., Kang, J. E., Han, H. W., Kim, J. M., Kim, G. H., & Yeom, G. Y. (2024). Effect of Bias Frequency on Bottom-Up SiO 2 Gap-Filling Using Plasma-Enhanced Atomic Layer Deposition. ACS Applied Materials & Interfaces, 16(31), 41642-41652. https://doi.org/10.1021/acsami.4c06106

Vancouver

Shin YJ, Kim HG, Choi SY, Kim SM, Kang JE, Han HW, et al. Effect of Bias Frequency on Bottom-Up SiO 2 Gap-Filling Using Plasma-Enhanced Atomic Layer Deposition. ACS Applied Materials & Interfaces. 2024;16(31):41642-41652. doi:10.1021/acsami.4c06106

BibTeX
@article{Shin2024,
  author = {Shin, Ye Ji and Kim, Ho Gon and Choi, Seung Yup and Kim, Seo Min and Kang, Ji Eun and Han, Hye Won and Kim, Ji Min and Kim, Geun Hwi and Yeom, Geun Young},
  title = {Effect of Bias Frequency on Bottom-Up SiO 2 Gap-Filling Using Plasma-Enhanced Atomic Layer Deposition},
  journal = {ACS Applied Materials & Interfaces},
  year = {2024},
  volume = {16},
  number = {31},
  pages = {41642--41652},
  doi = {10.1021/acsami.4c06106}
}
Kostenlos starten →