EUVIMEDEUVIMED entdecken
Crossref

Tuning Gate Potential Profiles and Current–Voltage Characteristics of Polymer Electrolyte-Gated Transistors by Capacitance Engineering

Kyung Gook Cho iD, Keun Hyung Lee iD, C Daniel Frisbie iD

ACS Applied Materials & Interfaces · 17.04.2024 · 16 (15) · 19309-19317

DOI: 10.1021/acsami.4c00079 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Materials & Interfaces, online erschienen am 09.04.2024. Verfasst von Kyung Gook Cho und 2 weiteren Autor:innen. Beteiligte Einrichtung: Department of Chemical Engineering and Materials Science, University of Minnesota-Twin Cities, Minneapolis, Minnesota 55455, United States. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 58 Literaturangaben. Gefördert von: National Research Foundation of Korea, Ministry of Trade, Industry and Energy, National Science Foundation.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

We demonstrate that the transfer characteristics of electrolyte-gated transistors (EGTs) with polythiophene semiconductor channels are a strong function of gate/electrolyte interfacial contact area, i.e., gate size. Polythiophene EGTs with gate/electrolyte areas much larger than the channel/electrolyte areas show a clear peak in the drain current vs gate voltage (ID-VG) behavior, as well as peak voltage hysteresis between the forward and reverse VG sweeps. Polythiophene EGTs with small gate/electrolyte areas, on the other hand, exhibit current plateaus in the ID-VG behavior and a gate-size-dependent hysteresis loop between turn on and off. The qualitatively different transport behaviors are attributed to the relative sizes of the gate/electrolyte and channel/electrolyte interface capacitances, which are proportional to interfacial area. These interfacial capacitances are in series with each other such that the total capacitance of the full gate/electrolyte/channel stack is dominated by the interface with the smallest capacitance or area. For EGTs with large gates, most of the applied VG is dropped at the channel/electrolyte interface, leading to very high charge accumulations, up to ∼0.3 holes per ring (hpr) in the case of polythiophene semiconductors. The large charge density results in sub-band-filling and a marked decrease in hole mobility, giving rise to the peak in ID-VG. For EGTs with small gates, hole accumulation saturates near 0.15 hpr, band-filling does not occur, and hole mobility is maintained at a fixed value, which leads to the ID plateau. Potential drops at the interfaces are confirmed by in situ potential measurements inside a gate/electrolyte/polymer semiconductor stack. Hole accumulations are measured with gate current-gate voltage (IG-VG) measurements acquired simultaneously with the ID-VG characteristics. Overall, our measurements demonstrate that remarkably different ID behavior can be obtained for polythiophene EGTs by controlling the magnitude of the gate-electrolyte interfacial capacitance.

Schlagwörter

Stichwörter der Autor:innen

capacitance engineeringelectrolyte-gated transistorshysteresisinterfacial potential droporganic electrochemical transistors

Autor:innen und Institutionen

  • Department of Chemical Engineering and Materials Science, University of Minnesota-Twin Cities, Minneapolis, Minnesota 55455, United States.
  • Department of Chemistry and Chemical Engineering, Education and Research Center for Smart Energy and Materials Inha University, Incheon 22212, Republic of Korea.

ORCID-Profile: Kyung Gook Cho, Keun Hyung Lee, C Daniel Frisbie

Förderung

  • National Research Foundation of Korea
  • Ministry of Trade, Industry and Energy
  • National Science Foundation

Zitieren

APA

Cho, K. G., Lee, K. H., & Frisbie, C. D. (2024). Tuning Gate Potential Profiles and Current–Voltage Characteristics of Polymer Electrolyte-Gated Transistors by Capacitance Engineering. ACS Applied Materials & Interfaces, 16(15), 19309-19317. https://doi.org/10.1021/acsami.4c00079

Vancouver

Cho KG, Lee KH, Frisbie CD. Tuning Gate Potential Profiles and Current–Voltage Characteristics of Polymer Electrolyte-Gated Transistors by Capacitance Engineering. ACS Applied Materials & Interfaces. 2024;16(15):19309-19317. doi:10.1021/acsami.4c00079

BibTeX
@article{Cho2024,
  author = {Cho, Kyung Gook and Lee, Keun Hyung and Frisbie, C Daniel},
  title = {Tuning Gate Potential Profiles and Current–Voltage Characteristics of Polymer Electrolyte-Gated Transistors by Capacitance Engineering},
  journal = {ACS Applied Materials & Interfaces},
  year = {2024},
  volume = {16},
  number = {15},
  pages = {19309--19317},
  doi = {10.1021/acsami.4c00079}
}
Kostenlos starten →