EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

p-Type Functionalized Carbon Nanohorns and Nanotubes in Perovskite Solar Cells

Helena Uceta iD, Andrea Cabrera-Espinoza iD, Myriam Barrejón iD, José G Sánchez iD, Edgar Gutierrez-Fernandez iD, Ivet Kosta iD, Jaime Martín iD, Silvia Collavini iD, Eugenia Martínez-Ferrero iD, Fernando Langa iD, Juan Luis Delgado iD

ACS Applied Materials & Interfaces · 27.09.2023 · 15 (38) · 45212-45228

DOI: 10.1021/acsami.3c07476 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Materials & Interfaces, online erschienen am 06.09.2023. Verfasst von Helena Uceta und 10 weiteren Autor:innen. Beteiligte Einrichtung: Instituto de Nanociencia, Nanotecnología y Materiales Moleculares (INAMOL), Universidad de Castilla-La Mancha, Avenida Carlos III S/N, Toledo 45071, …. Die Arbeit wurde bisher 19-mal zitiert (Crossref) und nennt 79 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministerio de Ciencia e Innovación, Ikerbasque, Basque Foundation for Science, Agència de Gestió d'Ajuts Universitaris i de Recerca.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

The incorporation of p-type functionalized carbon nanohorns (CNHs) in perovskite solar cells (PSCs) and their comparison with p-type functionalized single- and double-walled carbon nanotubes (SWCNTs and DWCNTs) are reported in this study for the first time. These p-type functionalized carbon nanomaterial (CNM) derivatives were successfully synthesized by [2 + 1] cycloaddition reaction with nitrenes formed from triphenylamine (TPA) and 9-phenyl carbazole (Cz)-based azides, yielding CNHs-TPA, CNHs-Cz, SWCNTs-Cz, SWCNTs-TPA, DWCNTs-TPA, and DWCNTs-Cz. These six novel CNMs were incorporated into the spiro-OMeTAD-based hole transport layer (HTL) to evaluate their impact on regular mesoporous PSCs. The photovoltaic results indicate that all p-type functionalized CNMs significantly improve the power conversion efficiency (PCE), mainly by enhancing the short-circuit current density (Jsc) and fill factor (FF). TPA-functionalized derivatives increased the PCE by 12-17% compared to the control device without CNMs, while Cz-functionalized derivatives resulted in a PCE increase of 4-8%. Devices prepared with p-type functionalized CNHs exhibited a slightly better PCE compared with those based on SWCNTs and DWCNTs derivatives. The increase in hole mobility of spiro-OMeTAD, additional p-type doping, better energy alignment with the perovskite layer, and enhanced morphology and contact interface play important roles in enhancing the performance of the device. Furthermore, the incorporation of p-type functionalized CNMs into the spiro-OMeTAD layer increased device stability by improving the hydrophobicity of the layer and enhancing the hole transport across the MAPI/spiro-OMeTAD interface. After 28 days under ambient conditions and darkness, TPA-functionalized CNMs maintained the performance of the device by over 90%, while Cz-functionalized CNMs preserved it between 75 and 85%.

Schlagwörter

Stichwörter der Autor:innen

additivescarbon nanohorns (CNHs)carbon nanomaterials (CNMs)double-walled carbon nanotubes (DWCNTs)p-type dopingperovskite solar cells (PSCs)single-walled carbon nanotubes (SWCNTs)spiro-OMeTAD

Autor:innen und Institutionen

  • Instituto de Nanociencia, Nanotecnología y Materiales Moleculares (INAMOL), Universidad de Castilla-La Mancha, Avenida Carlos III S/N, Toledo 45071, Spain.
  • POLYMAT, University of the Basque Country UPV/EHU, Avenida Tolosa 72, Donostia/San Sebastián 20018, Spain.
  • Institute of Chemical Research of Catalonia-The Barcelona Institute of Science and Technology (ICIQ-BIST), Avinguda Països Catalans 16, Tarragona 43007, Spain.
  • CIDETEC, Basque Research and Technology Alliance (BRTA), Paseo Miramón 196, Donostia/San Sebastián 20014, Spain.
  • Ikerbasque, Basque Foundation for Science, Bilbao 48013, Spain.

ORCID-Profile: Helena Uceta, Andrea Cabrera-Espinoza, Myriam Barrejón, José G Sánchez, Edgar Gutierrez-Fernandez, Ivet Kosta, Jaime Martín, Silvia Collavini, Eugenia Martínez-Ferrero, Fernando Langa, Juan Luis Delgado

Förderung

  • Ministerio de Ciencia e Innovación
  • Ikerbasque, Basque Foundation for Science
  • Agència de Gestió d'Ajuts Universitaris i de Recerca
  • Eusko Jaurlaritza
  • Ministerio de Educación, Cultura y Deporte
  • European Social Fund
  • Junta de Comunidades de Castilla-La Mancha
  • Polymat Foundation

Zitieren

APA

Uceta, H., Cabrera-Espinoza, A., Barrejón, M., Sánchez, J. G., Gutierrez-Fernandez, E., Kosta, I., Martín, J., Collavini, S., Martínez-Ferrero, E., Langa, F., & Delgado, J. L. (2023). p-Type Functionalized Carbon Nanohorns and Nanotubes in Perovskite Solar Cells. ACS Applied Materials & Interfaces, 15(38), 45212-45228. https://doi.org/10.1021/acsami.3c07476

Vancouver

Uceta H, Cabrera-Espinoza A, Barrejón M, Sánchez JG, Gutierrez-Fernandez E, Kosta I, et al. p-Type Functionalized Carbon Nanohorns and Nanotubes in Perovskite Solar Cells. ACS Applied Materials & Interfaces. 2023;15(38):45212-45228. doi:10.1021/acsami.3c07476

BibTeX
@article{Uceta2023,
  author = {Uceta, Helena and Cabrera-Espinoza, Andrea and Barrejón, Myriam and Sánchez, José G and Gutierrez-Fernandez, Edgar and Kosta, Ivet and Martín, Jaime and Collavini, Silvia and Martínez-Ferrero, Eugenia and Langa, Fernando and Delgado, Juan Luis},
  title = {p-Type Functionalized Carbon Nanohorns and Nanotubes in Perovskite Solar Cells},
  journal = {ACS Applied Materials & Interfaces},
  year = {2023},
  volume = {15},
  number = {38},
  pages = {45212--45228},
  doi = {10.1021/acsami.3c07476}
}
Kostenlos starten →