EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Engineered Fe2O3/TiO2/Carbon-Dots Heterostructures for Enhanced Photoelectrochemical Water Oxidation

Ehsan Mohammadi, Vittorio Ricci, Luigi Stagi, Stefania Mura, Luca Lozzi, Daiana Piccirilli, Plinio Innocenzi, Luca Malfatti, Carlo Cantalini, Valentina Paolucci

ACS Applied Energy Materials · 09.11.2026 · 9 (21) · 14042-14054

DOI: 10.1021/acsaem.6c02250 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Energy Materials, online erschienen am 27.10.2026. Verfasst von Ehsan Mohammadi und 9 weiteren Autor:innen. Die Arbeit nennt 49 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Ministero dell'Universit? e della Ricerca.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Hematite (α-Fe2O3) is an abundant, low-cost visible-light absorber and a leading photoanode candidate for solar-driven water splitting, yet its conversion efficiency remains constrained by poor charge transport, fast electron–hole recombination, and sluggish oxygen evolution reaction (OER) kinetics. Here, we engineer a Fe2O3/TiO2/Carbon-dot (C-dot) photoanode built on an FTO substrate that addresses these bottlenecks through a defined layer architecture: hydrothermally grown Fe2O3 nanorods provide visible-light absorption, a sol–gel-deposited mesoporous TiO2 overlayer passivates the hematite surface, and finally solvothermally grown C-dots decorate the outer surface to drive interfacial charge transfer. Structural and chemical characterization confirms a well-integrated, intimately contacted heterostructure, while optical measurements show that C-dot incorporation broadens visible-light harvesting without altering the underlying optical band gap (∼2.1 eV) indicating that any performance gain originates from charge-transport rather than band-structure effects. Under photoelectrochemical testing, the Fe2O3/TiO2/C-dots photoanode delivers substantially higher OER photocurrent than the Fe2O3/TiO2 baseline across the full UV-to-visible illumination range, with simulated-solar photocurrent density increasing by approximately 2.5-fold at neutral pH and by approximately 3.4-fold under alkaline conditions, pH 14, where OER kinetics are most favorable. The device sustains stable, reproducible photocurrent over multi-hour continuous solar illumination in both electrolytes, supporting its operational robustness under realistic water-splitting conditions. Mechanistically, Mott–Schottky analysis shows that C-dot incorporation more than doubles the carrier density (from 1.6 × 1020 to 3.3 × 1020 cm–3), while electrochemical impedance spectroscopy reveals a ∼27% reduction in interfacial charge-transfer resistance, together identifying enhanced carrier density and accelerated interfacial charge transfer, rather than band-edge modification, as the origin of the improved device performance. These results establish C-dot functionalization as a simple, scalable strategy for boosting the photocurrent and operational stability of Fe2O3/TiO2 photoanodes, with direct relevance to the design of higher-performing, low-cost solar-to-fuel conversion devices for water oxidation and solar hydrogen production.

Förderung

  • Ministero dell'Universit? e della Ricerca

Zitieren

APA

Mohammadi, E., Ricci, V., Stagi, L., Mura, S., Lozzi, L., Piccirilli, D., Innocenzi, P., Malfatti, L., Cantalini, C., & Paolucci, V. (2026). Engineered Fe2O3/TiO2/Carbon-Dots Heterostructures for Enhanced Photoelectrochemical Water Oxidation. ACS Applied Energy Materials, 9(21), 14042-14054. https://doi.org/10.1021/acsaem.6c02250

Vancouver

Mohammadi E, Ricci V, Stagi L, Mura S, Lozzi L, Piccirilli D, et al. Engineered Fe2O3/TiO2/Carbon-Dots Heterostructures for Enhanced Photoelectrochemical Water Oxidation. ACS Applied Energy Materials. 2026;9(21):14042-14054. doi:10.1021/acsaem.6c02250

BibTeX
@article{Mohammadi2026,
  author = {Mohammadi, Ehsan and Ricci, Vittorio and Stagi, Luigi and Mura, Stefania and Lozzi, Luca and Piccirilli, Daiana and Innocenzi, Plinio and Malfatti, Luca and Cantalini, Carlo and Paolucci, Valentina},
  title = {Engineered Fe2O3/TiO2/Carbon-Dots Heterostructures for Enhanced Photoelectrochemical Water Oxidation},
  journal = {ACS Applied Energy Materials},
  year = {2026},
  volume = {9},
  number = {21},
  pages = {14042--14054},
  doi = {10.1021/acsaem.6c02250}
}
Kostenlos starten →