Nonionic Amphiphilic Copolymers of Poly(poly(ethylene Glycol) Methacrylate) Brushes with Methyl Methacrylate Prepared by Atom Transfer Radical Polymerization as Dry Solid Polymer Electrolytes for Next Generation Li-ion Battery Applications
ACS Applied Energy Materials · 23.12.2024 · 7 (24) · 12036-12047
DOI: 10.1021/acsaem.4c02519 ↗Kurz gefasst
Fachartikel in der Zeitschrift ACS Applied Energy Materials, online erschienen am 09.12.2024. Verfasst von Ákos Szabó und 9 weiteren Autor:innen. Beteiligte Einrichtung: Polymer Chemistry and Physics Research Group, Institute of Materials and Environmental Chemistry, HUN-REN Research Centre for Natural Sciences, Magya…. Die Arbeit wurde bisher 6-mal zitiert (Crossref) und nennt 45 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Nemzeti Kutat?si, Fejleszt?si ?s Innovaci?s Alap, European Commission, European Regional Development Fund.
Abstract (Originalsprache)
Amphiphilic copolymers of comb-like poly(poly(ethylene glycol) methacrylate) (PPEGMA) with methyl methacrylate (MMA) synthesized by one-pot atom transfer radical polymerization were mixed with lithium bis (trifluoromethanesulfonyl) imide salt to formulate dry solid polymer electrolytes (DSPE) for semisolid-state Li-ion battery applications. The PEO-type side chain length (EO monomer's number) in the PEGMA macromonomer units was varied, and its influence on the mechanical and electrochemical characteristics was investigated. It was found that the copolymers, due to the presence of PMMA segments, possess viscoelastic behavior and less change in mechanical properties than a PEO homopolymer with 100 kDa molecular weight in the investigated temperature range. In contrast to the PEO homopolymer, it was found that no crystallization of the copolymers occurs in the presence of the Li-salt. Solid-state NMR and cross-polarization NMR studies revealed that no crystallization (i.e., ion-pair formation) of the Li-salt occurs in the case of the copolymer samples at ambient temperatures; thereby, no phase separation takes place, in contrast to the reference PEO homopolymer sample, which resulted in fairly good ionic conductivity of the copolymers at lower temperatures. The temperature-dependent Li-ion conductivity analyses showed that the conductivity of the copolymers falls in the 10-6-10-3 S/cm range, which is typical for polyether-type DSPEs, but the much lower mass fraction of EO monomers in the copolymers provides the same ionic conductivity values than that of the PEO homopolymer. From a large-scale practical point of view, this clearly indicates reduced Li-salt usage if such copolymer matrices are used instead of PEO homopolymer. Moreover, linear sweep voltammetry (LSV) polarization measurements showed that the PPEGMA-MMA copolymer electrolytes can exhibit a 200-300 mV broader electrochemical stability window than the PEO homopolymer, which is crucial in designing high energy density semisolid-state Li-ion batteries.
Autor:innen und Institutionen
- Polymer Chemistry and Physics Research Group, Institute of Materials and Environmental Chemistry, HUN-REN Research Centre for Natural Sciences, Magyar tudósok krt. 2., Budapest H-1117, Hungary.
- Department of Chemical and Environmental Process Engineering, Faculty of Chemical Technology and Biotechnology, Budapest University of Technology and Economics, Műegyetem rkp. 3, Budapest H-1111, Hungary.
- MTA-TTK Lendület "Momentum" Peptide-Based Vaccines Research Group, Institute of Materials and Environmental Chemistry, HUN-REN Research Centre for Natural Sciences, Budapest H-1117, Magyar tudósok krt. 2.
- Laboratory of Interfaces and Nanostructures, Institute of Chemistry, Eötvös Loránd University, 112, PO Box 32, Budapest H-1518, Hungary.
- Functional Interfaces Research Group, Institute of Materials and Environmental Chemistry, HUN-REN Research Centre for Natural Sciences, Magyar tudósok krt. 2., Budapest H-1117, Hungary.
- Soft Matters Group, Department of Physical Chemistry and Materials Science, Faculty of Chemical Technology and Biotechnology, Budapest University of Technology and Economics, Műegyetem rkp. 3, Budapest H-1111, Hungary.
ORCID-Profile: Robert Kun
Förderung
- Nemzeti Kutat?si, Fejleszt?si ?s Innovaci?s Alap
- European Commission
- European Regional Development Fund
- Emberi Eroforr?sok Miniszt?riuma
- State of Hungary
Zitieren
APA
Szabó, Á., Ershov, D., Ábrahám, Á., Kiss, É., Szarka, G., Felhősi, I., Gyarmati, B., Domján, A., Iván, B., & Kun, R. (2024). Nonionic Amphiphilic Copolymers of Poly(poly(ethylene Glycol) Methacrylate) Brushes with Methyl Methacrylate Prepared by Atom Transfer Radical Polymerization as Dry Solid Polymer Electrolytes for Next Generation Li-ion Battery Applications. ACS Applied Energy Materials, 7(24), 12036-12047. https://doi.org/10.1021/acsaem.4c02519
Vancouver
Szabó Á, Ershov D, Ábrahám Á, Kiss É, Szarka G, Felhősi I, et al. Nonionic Amphiphilic Copolymers of Poly(poly(ethylene Glycol) Methacrylate) Brushes with Methyl Methacrylate Prepared by Atom Transfer Radical Polymerization as Dry Solid Polymer Electrolytes for Next Generation Li-ion Battery Applications. ACS Applied Energy Materials. 2024;7(24):12036-12047. doi:10.1021/acsaem.4c02519
BibTeX
@article{Szab2024,
author = {Szabó, Ákos and Ershov, Denis and Ábrahám, Ágnes and Kiss, Éva and Szarka, Györgyi and Felhősi, Ilona and Gyarmati, Benjámin and Domján, Attila and Iván, Béla and Kun, Robert},
title = {Nonionic Amphiphilic Copolymers of Poly(poly(ethylene Glycol) Methacrylate) Brushes with Methyl Methacrylate Prepared by Atom Transfer Radical Polymerization as Dry Solid Polymer Electrolytes for Next Generation Li-ion Battery Applications},
journal = {ACS Applied Energy Materials},
year = {2024},
volume = {7},
number = {24},
pages = {12036--12047},
doi = {10.1021/acsaem.4c02519}
}
EUVIMED