EUVIMEDEUVIMED entdecken
Crossref

Interfacial Band Engineering in Solution-Processed CsPbBr3/Cs2AgBiBr6 Thin-Film Heterostructure for X-ray Detectors with High Sensitivity and Reduced Dark Current

Sellan Premkumar, Krishnaraj Lavanya, Ganapathi Bharathi, Sakthivel Chandrasekar, Pitchaikannu Venkatraman, Din Nasrud, Devaraj Nataraj, Byung Seong Bae, Damian Chinedu Onwudiwe, Lei Wei

ACS Applied Electronic Materials · 10.11.2026 · 8 (21) · 9542-9553

DOI: 10.1021/acsaelm.6c01631 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Electronic Materials, online erschienen am 31.10.2026. Verfasst von Sellan Premkumar und 9 weiteren Autor:innen. Die Arbeit nennt 45 Literaturangaben. Gefördert von: National Key Research and Development Program of China, Basic Research Program of Jiangsu Province, National Natural Science Foundation of China.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Metal halide perovskites are promising materials for direct X-ray detection owing to their strong X-ray absorption, solution processability, and efficient charge separation and transport. However, thin-film perovskite detectors usually suffer from trap-assisted recombination and grain-boundary-limited charge transport, while single-crystal devices often show relatively high dark current. Herein, we report a solution-processed CsPbBr3/Cs2AgBiBr6 heterostructure thin-film X-ray detector with suppressed leakage current and improved charge extraction through interfacial band engineering. Structural, optical, and morphological analyses confirmed the formation of crystalline perovskite films with a well-defined CsPbBr3/Cs2AgBiBr6 interface. Under X-ray irradiation, the CsPbBr3/Cs2AgBiBr6 heterostructure device exhibited the photocurrent values of ∼4.57–9.52 nA over the dose rate of 120 to 600 µGy s–1. Although this photocurrent is lower than that of the single-crystal device, the hybrid detector exhibited better device performance with improved sensitivity and good signal-to-noise-relevant performance. The heterostructure thin film detector has achieved sensitivities of 171, 112, and 92 µC Gy–1 cm–2 at dose rates of 120, 240, and 360 µGy s–1, respectively. Based on the SNR = 3 detection criterion, the heterostructure exhibited the lowest detectable dose rate of 34.9 µGy s–1. These results demonstrate that CsPbBr3/Cs2AgBiBr6 heterostructure engineering provides a practical strategy for developing low-dark-current, high-sensitivity perovskite thin-film X-ray detectors.

Förderung

  • National Key Research and Development Program of China
  • Basic Research Program of Jiangsu Province
  • National Natural Science Foundation of China
  • Higher Education Discipline Innovation Project
  • International cooperative research project of Jiangsu province

Zitieren

APA

Premkumar, S., Lavanya, K., Bharathi, G., Chandrasekar, S., Venkatraman, P., Nasrud, D., Nataraj, D., Bae, B. S., Onwudiwe, D. C., & Wei, L. (2026). Interfacial Band Engineering in Solution-Processed CsPbBr3/Cs2AgBiBr6 Thin-Film Heterostructure for X-ray Detectors with High Sensitivity and Reduced Dark Current. ACS Applied Electronic Materials, 8(21), 9542-9553. https://doi.org/10.1021/acsaelm.6c01631

Vancouver

Premkumar S, Lavanya K, Bharathi G, Chandrasekar S, Venkatraman P, Nasrud D, et al. Interfacial Band Engineering in Solution-Processed CsPbBr3/Cs2AgBiBr6 Thin-Film Heterostructure for X-ray Detectors with High Sensitivity and Reduced Dark Current. ACS Applied Electronic Materials. 2026;8(21):9542-9553. doi:10.1021/acsaelm.6c01631

BibTeX
@article{Premkumar2026,
  author = {Premkumar, Sellan and Lavanya, Krishnaraj and Bharathi, Ganapathi and Chandrasekar, Sakthivel and Venkatraman, Pitchaikannu and Nasrud, Din and Nataraj, Devaraj and Bae, Byung Seong and Onwudiwe, Damian Chinedu and Wei, Lei},
  title = {Interfacial Band Engineering in Solution-Processed CsPbBr3/Cs2AgBiBr6 Thin-Film Heterostructure for X-ray Detectors with High Sensitivity and Reduced Dark Current},
  journal = {ACS Applied Electronic Materials},
  year = {2026},
  volume = {8},
  number = {21},
  pages = {9542--9553},
  doi = {10.1021/acsaelm.6c01631}
}
Kostenlos starten →