EUVIMEDEUVIMED entdecken
Open Access · CC BY 4.0

Effects of Deposition Temperature on the Microstructure and Electrical Properties of 50 nm High-k BaTiO3 MIM Capacitors Fabricated by Atomic Layer Deposition

Jiayi Chen, Zekai Wang, Mengkun Tian, Chengyang Zhang, Lance Fernandes, Sanghyun Kang, Yu-Hsin Kuo, Taeyoung Song, Typher Yom, Hsin-Yun Joy Chao, Jefferey Baxter, Matthew Boebinger und 5 weitere

ACS Applied Electronic Materials · 10.11.2026 · 8 (21) · 9430-9438

DOI: 10.1021/acsaelm.6c01543 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Electronic Materials, online erschienen am 31.10.2026. Verfasst von Jiayi Chen und 16 weiteren Autor:innen. Die Arbeit nennt 40 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: Semiconductor Research Corporation, Division of Electrical, Communications and Cyber Systems.

AbstractBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Thermal atomic layer deposition (ALD) of BaTiO3 (BTO) is of interest for next-generation microelectronic devices, including RAM and NAND memory. Herein, we investigate the influence of deposition temperature on the microstructure and electronic properties of 50 nm BTO thin films fabricated by ALD at 200, 220, 240, and 280 °C using bis-(1,2,4 triisopropylcyclopentadienyl)-Ba [Ba(iPr3Cp2)], titanium isopropoxide, and water as precursors, and highlight the significance of void formation in films based on this chemistry. Self-limiting ALD behavior is observed, such that the deposition rate and Ba:Ti ratio are independent of prolonged Ba dose times. XRD shows that films deposited at 220 and 240 °C are significantly more crystalline than films deposited at 280 °C after annealing. Scanning electron microscopy reveals a difference in film microstructure depending on deposition temperature, indicative of different “structural zones”. Cross-sectional transmission electron microscopy reveals that annealed, crystallized BTO films are susceptible to void formation, especially when lower ALD deposition temperatures are used. This void formation appears to result from a combination of the microstructure of the as-deposited film and the easily hydrated barium constituent and is identified as an important structural defect that will need to be avoided to achieve desired dielectric performance. Electrical properties, such as capacitance–voltage (CV), dielectric loss, and DC current–voltage (IV), are closely correlated with microstructure. Fifty-nanometer BTO thin films deposited at 220, 240, and 280 °C have relative permittivity values (εr) of 73, 60, and 33, respectively, at 10 kHz after annealing. Dielectric loss (tanδ) is as low as 0.001. A modest dispersion in capacitance is observed across varying sampling frequencies. Future research to further understand and mitigate void formation while retaining proper stoichiometry for this ALD chemistry is recommended to further improve dielectric performance.

Förderung

  • Semiconductor Research Corporation
  • Division of Electrical, Communications and Cyber Systems

Zitieren

APA

Chen, J., Wang, Z., Tian, M., Zhang, C., Fernandes, L., Kang, S., Kuo, Y., Song, T., Yom, T., Chao, H. J., Baxter, J., Boebinger, M., Lee, S., Clendenning, S. B., Koo, W., Khan, A. I., & Losego, M. D. (2026). Effects of Deposition Temperature on the Microstructure and Electrical Properties of 50 nm High-k BaTiO3 MIM Capacitors Fabricated by Atomic Layer Deposition. ACS Applied Electronic Materials, 8(21), 9430-9438. https://doi.org/10.1021/acsaelm.6c01543

Vancouver

Chen J, Wang Z, Tian M, Zhang C, Fernandes L, Kang S, et al. Effects of Deposition Temperature on the Microstructure and Electrical Properties of 50 nm High-k BaTiO3 MIM Capacitors Fabricated by Atomic Layer Deposition. ACS Applied Electronic Materials. 2026;8(21):9430-9438. doi:10.1021/acsaelm.6c01543

BibTeX
@article{Chen2026,
  author = {Chen, Jiayi and Wang, Zekai and Tian, Mengkun and Zhang, Chengyang and Fernandes, Lance and Kang, Sanghyun and Kuo, Yu-Hsin and Song, Taeyoung and Yom, Typher and Chao, Hsin-Yun Joy and Baxter, Jefferey and Boebinger, Matthew and Lee, Sudarat and Clendenning, Scott B. and Koo, Won-Tae and Khan, Asif I. and Losego, Mark D.},
  title = {Effects of Deposition Temperature on the Microstructure and Electrical Properties of 50 nm High-k BaTiO3 MIM Capacitors Fabricated by Atomic Layer Deposition},
  journal = {ACS Applied Electronic Materials},
  year = {2026},
  volume = {8},
  number = {21},
  pages = {9430--9438},
  doi = {10.1021/acsaelm.6c01543}
}
Kostenlos starten →