EUVIMEDEUVIMED entdecken
Crossref

Modulation of MG-63 Osteogenic Response on Mechano-Bactericidal Micronanostructured Titanium Surfaces

Karolinne Martins de Sousa iD, Denver P Linklater iD, Billy J Murdoch iD, Mohammad Al Kobaisi, Russell J Crawford, Roy Judge, Stuart Dashper, Alastair J Sloan, Dusan Losic iD, Elena P Ivanova iD

ACS Applied Bio Materials · 20.03.2023 · 6 (3) · 1054-1070

DOI: 10.1021/acsabm.2c00952 ↗

Kurz gefasst

Fachartikel in der Zeitschrift ACS Applied Bio Materials, online erschienen am 07.03.2023. Verfasst von Karolinne Martins de Sousa und 9 weiteren Autor:innen. Beteiligte Einrichtung: School of Science, STEM College, RMIT University, Melbourne, Victoria 3000, Australia. Hauptthemen laut MEDLINE: Titanium, Staphylococcus aureus. Die Arbeit wurde bisher 12-mal zitiert (Crossref) und nennt 68 Literaturangaben. Gefördert von: Australian Research Council Industrial Transformational Training (ITTC) Centre in Surface Engineering for Advanced Materials (SEAM).

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Despite recent advances in the development of orthopedic devices, implant-related failures that occur as a result of poor osseointegration and nosocomial infection are frequent. In this study, we developed a multiscale titanium (Ti) surface topography that promotes both osteogenic and mechano-bactericidal activity using a simple two-step fabrication approach. The response of MG-63 osteoblast-like cells and antibacterial activity toward Pseudomonas aeruginosa and Staphylococcus aureus bacteria was compared for two distinct micronanoarchitectures of differing surface roughness created by acid etching, using either hydrochloric acid (HCl) or sulfuric acid (H2SO4), followed by hydrothermal treatment, henceforth referred to as either MN-HCl or MN-H2SO4. The MN-HCl surfaces were characterized by an average surface microroughness (Sa) of 0.8 ± 0.1 μm covered by blade-like nanosheets of 10 ± 2.1 nm thickness, whereas the MN-H2SO4 surfaces exhibited a greater Sa value of 5.8 ± 0.6 μm, with a network of nanosheets of 20 ± 2.6 nm thickness. Both micronanostructured surfaces promoted enhanced MG-63 attachment and differentiation; however, cell proliferation was only significantly increased on MN-HCl surfaces. In addition, the MN-HCl surface exhibited increased levels of bactericidal activity, with only 0.6% of the P. aeruginosa cells and approximately 5% S. aureus cells remaining viable after 24 h when compared to control surfaces. Thus, we propose the modulation of surface roughness and architecture on the micro- and nanoscale to achieve efficient manipulation of osteogenic cell response combined with mechanical antibacterial activity. The outcomes of this study provide significant insight into the further development of advanced multifunctional orthopedic implant surfaces.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

TitaniumStaphylococcus aureusSurface PropertiesOsteogenesisAnti-Bacterial Agents

Stichwörter der Autor:innen

antibacterial surfacesbone-titanium integrationhierarchical micronanotopographymechano-bactericidal surfacessurface engineering

Substanzen

TitaniumAnti-Bacterial Agents

Autor:innen und Institutionen

  • School of Science, STEM College, RMIT University, Melbourne, Victoria 3000, Australia.
  • Department of Biomedical Engineering, The University of Melbourne, Parkville, Victoria 3010, Australia.
  • RMIT Microscopy and Microanalysis Facility, STEM College, RMIT University, Melbourne, Victoria 3000, Australia.
  • School of Engineering, STEM College, RMIT University, Melbourne, Victoria 3000, Australia.
  • Melbourne Dental School, Faculty of Medicine, Dentistry & Health Sciences, The University of Melbourne, Parkville, Victoria 3010, Australia.
  • School of Chemical Engineering and Advanced Materials, The University of Adelaide, Adelaide, South Australia 5005, Australia.

ORCID-Profile: Karolinne Martins de Sousa, Denver P Linklater, Billy J Murdoch, Dusan Losic, Elena P Ivanova

Förderung

  • Australian Research Council Industrial Transformational Training (ITTC) Centre in Surface Engineering for Advanced Materials (SEAM)

Zitieren

APA

Martins de Sousa, K., Linklater, D. P., Murdoch, B. J., Al Kobaisi, M., Crawford, R. J., Judge, R., Dashper, S., Sloan, A. J., Losic, D., & Ivanova, E. P. (2023). Modulation of MG-63 Osteogenic Response on Mechano-Bactericidal Micronanostructured Titanium Surfaces. ACS Applied Bio Materials, 6(3), 1054-1070. https://doi.org/10.1021/acsabm.2c00952

Vancouver

Martins de Sousa K, Linklater DP, Murdoch BJ, Al Kobaisi M, Crawford RJ, Judge R, et al. Modulation of MG-63 Osteogenic Response on Mechano-Bactericidal Micronanostructured Titanium Surfaces. ACS Applied Bio Materials. 2023;6(3):1054-1070. doi:10.1021/acsabm.2c00952

BibTeX
@article{MartinsdeSousa2023,
  author = {Martins de Sousa, Karolinne and Linklater, Denver P and Murdoch, Billy J and Al Kobaisi, Mohammad and Crawford, Russell J and Judge, Roy and Dashper, Stuart and Sloan, Alastair J and Losic, Dusan and Ivanova, Elena P},
  title = {Modulation of MG-63 Osteogenic Response on Mechano-Bactericidal Micronanostructured Titanium Surfaces},
  journal = {ACS Applied Bio Materials},
  year = {2023},
  volume = {6},
  number = {3},
  pages = {1054--1070},
  doi = {10.1021/acsabm.2c00952}
}
Kostenlos starten →