Release of Bisphenol A and Other Volatile Chemicals from New Epoxy Drinking Water Pipe Liners: The Role of Manufacturing Conditions
Environmental Science & Technology · 2025
DOI: 10.1021/acs.est.4c08663 ↗Kurz gefasst
Fachartikel in der Zeitschrift Environmental Science & Technology, 2025. Verfasst von Pritee Pahari und 11 weiteren Autor:innen. Beteiligte Einrichtung: Lyles School of Civil Engineering, Purdue University, 550 Stadium Mall Drive, West Lafayette, Indiana 47907, United States. Hauptthemen laut MEDLINE: Phenols, Drinking Water, Benzhydryl Compounds, Volatile Organic Compounds. Die Arbeit wurde bisher 13-mal zitiert (Crossref) und nennt 91 Literaturangaben. Der Volltext ist frei zugänglich (Open Access, CC BY 4.0). Gefördert von: National Science Foundation, Purdue University, Warm Springs Foundation.
Abstract (Originalsprache)
Cured-in-place-pipe (CIPP) technology has begun to be adopted for drinking water pipe repairs, and limited information exists about its drinking water quality impacts. CIPP involves the manufacture of a new plastic pipe inside a buried damaged pipe. In this study, the chemical composition of the raw materials and CIPP water quality impacts were examined. Numerous (47) VOCs and SVOCs were found in the resin and two hardeners were studied. TGA results indicated that new CIPPs contained about 3.2–4.8 wt% VOC. A controlled static headspace analysis using PTR-TOF-MS detected eight protonated ions (m/z < 114) with mixing ratios above 1 ppb and phenol was identified as the most abundant VOC released into air. The analytical methods were unable to identify 99.9% of the extractable VOC mass. A 5% shorter curing duration had no impact on the chemical residual left in the CIPPs, but a 5% hardener reduction prompted an increase in the amount of monomer remaining. Both normal drying and quick drying formulations released similar amounts of 2-EHGE and BPA into drinking water. Laboratory results scaled to 4–36 in. diameter pipes indicated only 4 in. diameter CIPPs would cause BPA levels to exceed a U.S. state drinking water standard, EU, and WHO drinking water limits. Flushing and drinking water VOC and SVOC testing should be conducted before use. Additional studies of resins, manufacturing conditions, and wastes generated, are recommended. At present, the limited information available about these materials has shifted the burden of potential health and financial costs to the users.
Schlagwörter
MeSH-Schlagwörter (MEDLINE)
Stichwörter der Autor:innen
Substanzen
Autor:innen und Institutionen
- Lyles School of Civil Engineering, Purdue University, 550 Stadium Mall Drive, West Lafayette, Indiana 47907, United States.
- Division of Environmental and Ecological Engineering, Purdue University, 610 Purdue Mall, West Lafayette, Indiana 47907, United States.
- Department of Civil and Environmental Engineering, Howard University, 2300 Sixth Street NW, Washington, D.C. 20059, United States.
- School of Materials Engineering, Division of Environmental and Ecological Engineering, Purdue University, 610 Purdue Mall, West Lafayette, Indiana 47907, United States.
- School of Agricultural and Biological Engineering, Division of Environmental and Ecological Engineering, Purdue University, 610 Purdue Mall, West Lafayette, Indiana 47907, United States.
- School of Materials Engineering, Purdue University, 701 West Stadium Avenue, West Lafayette, Indiana 47907, United States.
ORCID-Profile: Caitlin R Proctor, John A Howarter, Jeffery Paul Youngblood, Nusrat Jung, Andrew J Whelton
Förderung
- National Science Foundation
- Purdue University
- Warm Springs Foundation
Zitieren
APA
Pahari, P., Spears, S., Liu, J., Butler, S., Sonowane, S., Garcia, A., Larsen, M., Proctor, C. R., Howarter, J. A., Youngblood, J. P., Jung, N., & Whelton, A. J. (2025). Release of Bisphenol A and Other Volatile Chemicals from New Epoxy Drinking Water Pipe Liners: The Role of Manufacturing Conditions. Environmental Science & Technology. https://doi.org/10.1021/acs.est.4c08663
Vancouver
Pahari P, Spears S, Liu J, Butler S, Sonowane S, Garcia A, et al. Release of Bisphenol A and Other Volatile Chemicals from New Epoxy Drinking Water Pipe Liners: The Role of Manufacturing Conditions. Environmental Science & Technology. 2025. doi:10.1021/acs.est.4c08663
BibTeX
@article{Pahari2025,
author = {Pahari, Pritee and Spears, Samuel and Liu, Jianghui and Butler, Sydney and Sonowane, Shantanu and Garcia, Anthony and Larsen, Madeline and Proctor, Caitlin R and Howarter, John A and Youngblood, Jeffery Paul and Jung, Nusrat and Whelton, Andrew J},
title = {Release of Bisphenol A and Other Volatile Chemicals from New Epoxy Drinking Water Pipe Liners: The Role of Manufacturing Conditions},
journal = {Environmental Science & Technology},
year = {2025},
doi = {10.1021/acs.est.4c08663}
}
EUVIMED