EUVIMEDEUVIMED entdecken
Crossref

A multiaxial bioreactor system that applies targeted magnitudes of strain energy to 3D cellular constructs

Amevi M Semodji, John B Everingham, Katherine A Hollar, Danielle N Siegel, Samantha E Jamison, Faith R Wilder, Gunes Uzer, Trevor J Lujan

Journal of the Mechanical Behavior of Biomedical Materials · 2025

DOI: 10.1016/j.jmbbm.2025.106983 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of the Mechanical Behavior of Biomedical Materials, 2025. Verfasst von Amevi M Semodji und 7 weiteren Autor:innen. Beteiligte Einrichtung: Biomedical Engineering Doctoral Program, Boise State University, Boise, ID, USA. Hauptthemen laut MEDLINE: Bioreactors, Stress, Mechanical. Die Arbeit nennt 56 Literaturangaben. Gefördert von: NIH HHS, NIAMS NIH HHS, NIGMS NIH HHS.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Cyclic mechanical stimulation is instrumental in the remodeling and engineering of musculoskeletal tissue, yet the physical mechanisms that regulate this mechanobiological response are poorly understood. A plausible explanation is that extracellular matrix remodeling is governed by the strain energy that develops during tissue distortion and dilation. A major barrier to testing strain energy-based theories is the absence of in vitro experimental methods that can prescribe targeted amounts of strain energy to 3D cellular constructs under different physiological loads for given thermodynamic constraints. Therefore, we designed and built a multiaxial bioreactor that can simultaneously apply cyclic tensile and compressive loads to 3D specimens. Total strain energy is computed and decoupled into distortion and hydrostatic parts using a numerical approach that we developed and verified. A control system adjusts the loads until a user-specified magnitude of total strain energy (per loading cycle) is achieved under uniaxial or biaxial stress conditions. The bioreactor system successfully applied the targeted strain energy of 100 J/m3 to acellular polyurethane scaffolds subjected to uniaxial tension, uniaxial compression, and biaxial tension-compression with errors < 5 %. We then tested the bioreactor's ability to stimulate fibroblast-seeded 3D collagen scaffolds and found that, compared to unstimulated controls, cell viability significantly increased when targeted levels of strain energy (biaxial tension-compression) were periodically applied during two days of culture. By specifically controlling strain energy in 3D cellular constructs, this new testing methodology will allow the investigation of energy-based mechanobiological theories and may assist the advancement of musculoskeletal tissue engineering.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

BioreactorsStress, MechanicalAnimalsTissue ScaffoldsFibroblastsTissue EngineeringMice

Stichwörter der Autor:innen

Collagen remodelingCyclic mechanical stimulationEnergy conjugatesFibroblast mechanobiologyMusculoskeletal tissue engineeringTissue distortion

Autor:innen und Institutionen

  • Biomedical Engineering Doctoral Program, Boise State University, Boise, ID, USA.
  • Department of Mechanical & Biomedical Engineering, Boise State University, Boise, ID, USA.
  • Micron School of Materials Science & Engineering, Boise State University, Boise, ID, USA.
  • Biomedical Engineering Doctoral Program, Boise State University, Boise, ID, USA; Department of Mechanical & Biomedical Engineering, Boise State University, Boise, ID, USA.
  • Biomedical Engineering Doctoral Program, Boise State University, Boise, ID, USA; Department of Mechanical & Biomedical Engineering, Boise State University, Boise, ID, USA. Electronic address: trevorlujan@boisestate.edu.

Förderung

  • NIH HHS
  • NIAMS NIH HHS
  • NIGMS NIH HHS
  • National Institutes of Health Office of Research Infrastructure Programs
  • National Institute of Arthritis and Musculoskeletal and Skin Diseases
  • NIH National Institute of General Medical Sciences

Zitieren

APA

Semodji, A. M., Everingham, J. B., Hollar, K. A., Siegel, D. N., Jamison, S. E., Wilder, F. R., Uzer, G., & Lujan, T. J. (2025). A multiaxial bioreactor system that applies targeted magnitudes of strain energy to 3D cellular constructs. Journal of the Mechanical Behavior of Biomedical Materials. https://doi.org/10.1016/j.jmbbm.2025.106983

Vancouver

Semodji AM, Everingham JB, Hollar KA, Siegel DN, Jamison SE, Wilder FR, et al. A multiaxial bioreactor system that applies targeted magnitudes of strain energy to 3D cellular constructs. Journal of the Mechanical Behavior of Biomedical Materials. 2025. doi:10.1016/j.jmbbm.2025.106983

BibTeX
@article{Semodji2025,
  author = {Semodji, Amevi M and Everingham, John B and Hollar, Katherine A and Siegel, Danielle N and Jamison, Samantha E and Wilder, Faith R and Uzer, Gunes and Lujan, Trevor J},
  title = {A multiaxial bioreactor system that applies targeted magnitudes of strain energy to 3D cellular constructs},
  journal = {Journal of the Mechanical Behavior of Biomedical Materials},
  year = {2025},
  doi = {10.1016/j.jmbbm.2025.106983}
}
Kostenlos starten →