EUVIMEDEUVIMED entdecken
Crossref

Low-temperature NH3 abatement via selective oxidation over a supported copper catalyst with high Cu+ abundance

Zhiming Yang, Lin Peng, Leneng Yang, Mingli Fu, Daiqi Ye, Peirong Chen

Journal of Environmental Sciences · 2024-09 · 143 · 12-22

DOI: 10.1016/j.jes.2023.05.047 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Environmental Sciences, 2024-09. Verfasst von Zhiming Yang und 5 weiteren Autor:innen. Beteiligte Einrichtung: Guangdong Provincial Key Laboratory of Atmospheric Environment and Pollution Control, National Engineering Laboratory for VOCs Pollution Control Tech…. Hauptthemen laut MEDLINE: Copper, Ammonia, Oxidation-Reduction. Die Arbeit wurde bisher 12-mal zitiert (Crossref) und nennt 59 Literaturangaben.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Selective catalytic NH3-to-N2 oxidation (NH3-SCO) is highly promising for abating NH3 emissions slipped from stationary flue gas after-treatment devices. Its practical application, however, is limited by the non-availability of low-cost catalysts with high activity and N2 selectivity. Here, using defect-rich nitrogen-doped carbon nanotubes (NCNT-AW) as the support, we developed a highly active and durable copper-based NH3-SCO catalyst with a high abundance of cuprous (Cu+) sites. The obtained Cu/NCNT-AW catalyst demonstrated outstanding activity with a T50 (i.e. the temperature to reach 50% NH3 conversion) of 174°C in the NH3-SCO reaction, which outperformed not only the Cu catalyst supported on N-free O-functionalized CNTs (OCNTs) or NCNT with less surface defects, but also those most active Cu catalysts in open literature. Reaction kinetics measurements and temperature-programmed surface reactions using NH3 as a probe molecule revealed that the NH3-SCO reaction on Cu/NCNT-AW follows an internal selective catalytic reaction (i-SCR) route involving nitric oxide (NO) as a key intermediate. According to mechanistic investigations by X-ray photoelectron spectroscopy, Raman spectroscopy, and X-ray absorption spectroscopy, the superior NH3-SCO performance of Cu/NCNT-AW originated from a synergy of surface defects and N-dopants. Specifically, surface defects promoted the anchoring of CuO nanoparticles on N-containing sites and, thereby, enabled efficient electron transfer from N to CuO, increasing significantly the fraction of SCR-active Cu+ sites in the catalyst. This study puts forward a new idea for manipulating and utilizing the interplay of defects and N-dopants on carbon surfaces to fabricate Cu+-rich Cu catalysts for efficient abatement of slip NH3 emissions via selective oxidation.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

CopperAmmoniaOxidation-ReductionCatalysisNanotubes, CarbonAir PollutantsTemperatureModels, Chemical

Stichwörter der Autor:innen

Localized etchingN(2) selectivityN-dopingNH(3)-SCOXANESi-SCR

Substanzen

CopperAmmoniaNanotubes, CarbonAir Pollutants

Autor:innen und Institutionen

  • Guangdong Provincial Key Laboratory of Atmospheric Environment and Pollution Control, National Engineering Laboratory for VOCs Pollution Control Technology and Equipment, School of Environment and Energy, South China Un…
  • Guangdong Chengyi Environmental Technology Corp., Shaoguan 512158, China.

Zitieren

APA

Yang, Z., Peng, L., Yang, L., Fu, M., Ye, D., & Chen, P. (2024). Low-temperature NH3 abatement via selective oxidation over a supported copper catalyst with high Cu+ abundance. Journal of Environmental Sciences, 143, 12-22. https://doi.org/10.1016/j.jes.2023.05.047

Vancouver

Yang Z, Peng L, Yang L, Fu M, Ye D, Chen P. Low-temperature NH3 abatement via selective oxidation over a supported copper catalyst with high Cu+ abundance. Journal of Environmental Sciences. 2024;143:12-22. doi:10.1016/j.jes.2023.05.047

BibTeX
@article{Yang2024,
  author = {Yang, Zhiming and Peng, Lin and Yang, Leneng and Fu, Mingli and Ye, Daiqi and Chen, Peirong},
  title = {Low-temperature NH3 abatement via selective oxidation over a supported copper catalyst with high Cu+ abundance},
  journal = {Journal of Environmental Sciences},
  year = {2024},
  volume = {143},
  pages = {12--22},
  doi = {10.1016/j.jes.2023.05.047}
}
Kostenlos starten →