EUVIMEDEUVIMED entdecken
Crossref

In-situ sulfur fixation using aluminum-based sorbents during the pyrolysis of sulfur-containing waste polymers

Yue Sheng, Longfei Tang, Peipei Gao, Weitong Pan, Lu Ding, Xueli Chen, Fuchen Wang

Journal of Environmental Management · 2026-04 · 405 · 129764

DOI: 10.1016/j.jenvman.2026.129764 ↗

Kurz gefasst

Fachartikel in der Zeitschrift Journal of Environmental Management, 2026-04. Verfasst von Yue Sheng und 6 weiteren Autor:innen. Beteiligte Einrichtung: Engineering Research Center of Resource Utilization of Carbon-containing Waste with Carbon Neutrality, Ministry of Education, Shanghai, 200237, PR Ch…. Hauptthemen laut MEDLINE: Sulfur, Polymers, Aluminum. Die Arbeit wurde bisher 1-mal zitiert (Crossref) und nennt 63 Literaturangaben. Gefördert von: National Natural Science Foundation of China, Fundamental Research Funds for the Central Universities, National Key Research and Development Program of China.

AbstractSchlagwörterBibliografische AngabenZitierenVerwandte Studien

Abstract (Originalsprache)

Hazardous sulfur species (H2S, thiophenes, etc.) are released during pyrolysis of sulfur-containing plastics (PPS, etc.), challenging their recycling. Aluminum-based sorbents (M-Al-O, where M = Ca, Zn, Cu, Fe) were evaluated for in-situ sulfur capture performance. Results showed that all sorbents increased sulfur in char to 71.09-79.67%, compared to 48.56% without sorbent. The overall sulfur regulation performance followed the order: Cu-Al-O > Fe-Al-O > Ca-Al-O > Zn-Al-O. Ca-Al-O minimized sulfur in tar (6.71%) by inhibiting oligomer/thiophene formation. Zn-Al-O promoted PPS depolymerization but showed limited cracking activity, raising tar sulfur (8.19%). Cu-Al-O and Fe-Al-O achieved high H2S fixation (>92.40%). Cu-Al-O facilitated decomposition of dimers and trimers while promoting polycyclic thiophenes. Fe-Al-O exhibited limited tar sulfur suppression (7.45%) due to ineffective oligomer cracking. Based on these complementary mechanisms, a synergistic Ca-Cu-Al-O composite sorbent was designed. Sulfur fixation efficiency increased with sorbent loading (74.18-93.67%). At a 1:1 ratio, sulfur fixation efficiency reached 86.24%, and the tar sulfur concentration was reduced to 44,480 ppm, below the calculated additive value of 48,458 ppm. In this system, CuAl2O4 promoted the cracking of oligomers, reducing trimer content by 61.51-94.66%, while Ca3Al2O6 suppressed thiophene formation, decreasing benzodibenzothiophene intensity by 2.33-52.3%. Sulfur was fixed as CaS, which mitigated poisoning of copper active sites and preserved their catalytic activity for oligomer cracking. This work elucidates the role of aluminum-based sorbents in regulating sulfur transformation and provides a viable strategy for clean recycling of sulfur-containing plastics.

Schlagwörter

MeSH-Schlagwörter (MEDLINE)

SulfurPolymersAluminumPyrolysisAdsorption

Stichwörter der Autor:innen

Aluminum-based sorbentsPolyphenylene sulfidePyrolysisSulfur fixationSulfur-containing waste plastics

Substanzen

SulfurPolymersAluminum

Autor:innen und Institutionen

  • Engineering Research Center of Resource Utilization of Carbon-containing Waste with Carbon Neutrality, Ministry of Education, Shanghai, 200237, PR China; Shanghai Engineering Research Center of Coal Gasification, East C…
  • Institute of Low-Carbon Technology Innovation, School of Environment and Architecture, University of Shanghai for Science and Technology, Shanghai, 200093, PR China.

Förderung

  • National Natural Science Foundation of China
  • Fundamental Research Funds for the Central Universities
  • National Key Research and Development Program of China

Zitieren

APA

Sheng, Y., Tang, L., Gao, P., Pan, W., Ding, L., Chen, X., & Wang, F. (2026). In-situ sulfur fixation using aluminum-based sorbents during the pyrolysis of sulfur-containing waste polymers. Journal of Environmental Management, 405, 129764. https://doi.org/10.1016/j.jenvman.2026.129764

Vancouver

Sheng Y, Tang L, Gao P, Pan W, Ding L, Chen X, et al. In-situ sulfur fixation using aluminum-based sorbents during the pyrolysis of sulfur-containing waste polymers. Journal of Environmental Management. 2026;405:129764. doi:10.1016/j.jenvman.2026.129764

BibTeX
@article{Sheng2026,
  author = {Sheng, Yue and Tang, Longfei and Gao, Peipei and Pan, Weitong and Ding, Lu and Chen, Xueli and Wang, Fuchen},
  title = {In-situ sulfur fixation using aluminum-based sorbents during the pyrolysis of sulfur-containing waste polymers},
  journal = {Journal of Environmental Management},
  year = {2026},
  volume = {405},
  pages = {129764},
  doi = {10.1016/j.jenvman.2026.129764}
}
Kostenlos starten →